2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS
Application Belt Assembly Anchor Bolt Body Lock Pillar Garnish Molding Screws Body Rear Corner Upper Garnish Molding Screws Center Pillar Upper Assist Handle Screws Center Pillar Upper Garnish Molding Screws Coat Hook Screws Floor Console Bolts Front Floor Console Rear Cupholder Screw Jack and Tool Stowage Container Retaining Nut Liftgate Trim Finish Panel Screw Overhead Console Screws Quarter Panel Trim Armrest Screws Quarter Panel Trim Screws Rear Assist Handle Screws Side Door Armrest Bolt Side Door Trim Panel Bolt Sunshade Screws Tool Storage Compartment Bracket Nuts Tool Storage Compartment Nuts Windshield Side Garnish Molding Screws Windshield Side Pillar Assist Handle Screws
Specification Metric English 70 N.m 52 lb ft 2 N.m 18 lb in 2 N.m 18 lb in 1.2 N.m 10 lb in 2 N.m 18 lb in 9 N.m 80 lb in 6 N.m 53 lb in 2 N.m 18 lb in 5 N.m 44 lb in 2 N.m 18 lb in 2 N.m 18 lb in 2 N.m 18 lb in 2 N.m 18 lb in 6 N.m 53 lb in 2 N.m 18 lb in 2 N.m 18 lb in 6 N.m 53 lb in 50 N.m 36 lb ft 10 N.m 88 lb in 2 N.m 18 lb in 6 N.m 53 lb in
REPAIR INSTRUCTIONS FRONT DOOR SWITCH BEZEL REPLACEMENT
MY Tuesday, April 07, 2009 4:48:33 4:48:29 PM
Page 1
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
MY Tuesday, April 07, 2009 4:48:29 PM
Page 2
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 1: View Of Front Door Switch Bezel Courtesy of GENERAL MOTORS CORP. Callout
Component Name Front Side Door Window Switch Bezel Procedure
1
1. Pull upward on the switch bezel assembly to disengage the retainer clips from the door trim panel. 2. Disconnect the electrical connectors.
FRONT SIDE DOOR PULL HANDLE REPLACEMENT
MY Tuesday, April 07, 2009 4:48:29 PM
Page 3
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 2: View Of Front Side Door Pull Handle Courtesy of GENERAL MOTORS CORP. MY Tuesday, April 07, 2009 4:48:29 PM
Page 4
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Callout Component Name 1 Front Side Door Pull Handle Cover Front Side Door Pull Handle Bolt (Qty: 2) 2
3
NOTE: Refer to Fastener Notice .
Tighten: 6 N.m (54 lb in) Front Side Door Pull Handle Assembly
UPPER EXTENSION TRIM PANEL REPLACEMENT
MY Tuesday, April 07, 2009 4:48:29 PM
Page 5
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 3: View Of Upper Extension Trim Panel MY Tuesday, April 07, 2009 4:48:29 PM
Page 6
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Courtesy of GENERAL MOTORS CORP. Callout Component Name 1 Front Side Door Upper Trim Panel Assembly 2 Front Side Door Upper Trim Panel Clip (Qty: 3) FRONT SIDE DOOR TRIM PANEL REPLACEMENT (YE9)
Fig. 4: View Of Front Side Door Trim Panel (YE9) Courtesy of GENERAL MOTORS CORP. Callout
Component Name
Preliminary Procedure 1. Remove upper extension trim panel. Refer to Upper Extension Trim Panel Replacement. 2. Remove door pull handle. Refer to Front Side Door Pull Handle Replacement. 3. Remove door lock and window control switch (if equipped). Refer to Door Lock and Side Window Switch Replacement - Driver Side and Door Lock and Side Window Switch Replacement - Passenger Side . MY Tuesday, April 07, 2009 4:48:29 PM
Page 7
© 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
4. Remove the door window regulator handle (if equipped). Refer to Door Window Regulator Handle Replacement . Front Side Door Locking Rod Knob Assembly Tip:
1
2 3
4
1. Lower window. 2. Ensure locking rod is in the unlocked position. 3. Use a flat-bladed tool to disengage detent tab and then remove knob by pulling upward. 4. When re-installing, push knob down until detent tab touches locking rod opening cover. 5. Push detent tab in to lock knob to locking rod. Front Side Door Release Handle Cover Front Side Door Armrest Opening Cover Front Side Door Trim Panel Bolt (Qty: 3) NOTE: Refer to Fastener Notice .
Tighten: 2 N.m (18 lb in) Front Side Door Trim Panel Assembly Tip: 5
6
1. Disengage door lock cable. 2. There are two hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY. 3. If these hook are damaged during either removal or installation of the door trim panel, replacement of the panel is not required. Front Side Door Trim Panel Retainer (Qty: 11)
FRONT SIDE DOOR TRIM PANEL REPLACEMENT (SLT)
MY Tuesday, April 07, 2009 4:48:29 PM
Page 8
Š 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 5: View Of Front Side Door Trim Panel (SLT) Courtesy of GENERAL MOTORS CORP. Callout Preliminary Procedure
Component Name
1. Remove the door upper trim panel. Refer to Upper Extension Trim Panel Replacement. 2. Remove the door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver Side and Door Lock and Side Window Switch Replacement - Passenger Side . Front Side Door Locking Rod Knob Assembly Tip:
1
1. Lower the window. 2. Ensure the locking rod is in the unlocked position. 3. Use a flat-bladed tool to disengage the detent tab and then remove the knob by pulling upward. 4. When re-installing, push the knob down until the detent tab touches the locking rod opening cover.
MY Tuesday, April 07, 2009 4:48:29 PM
Page 9
Š 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
2 3 4
5. Push the detent tab in to lock the knob to the locking rod. Front Side Door Trim Panel Cover Front Side Door Trim Panel Cover Retainer (Qty: 3) Front Side Door Inside Handle Bezel Cover Front Side Door Trim Panel Bolt (Qty: 3)
5
NOTE: Refer to Fastener Notice .
Tighten: 2 N.m (18 lb in) Front Side Door Trim Panel Assembly Tip:
6
7 8
1. Disconnect the electrical connectors. 2. There are 2 hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY. 3. If these hooks are damaged during either removal or installation of the door trim panel, replacement of the panel is not required. 4. When installing the trim panel start at the lock knob, pushing down and outward moving toward the upper front. Front Side Door Cable Retainer Tip: Pull upward to disengage. Front Side Door Trim Panel Retainer (Qty: 12)
REAR SIDE DOOR TRIM PANEL REPLACEMENT (YE9)
MY Tuesday, April 07, 2009 4:48:29 PM
Page 10
Š 2005 Mitchell Repair Information Company, LLC.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 6: View Of Rear Side Door Trim Panel (YE9) Courtesy of GENERAL MOTORS CORP. Callout Preliminary Procedure
Component Name
1. Remove the window control switch, if equipped. Refer to Rear Side Door Window Switch Replacement (Crew Cab) or Rear Side Door Window Switch Replacement (Extended Cab) . 2. Remove the door window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement . Rear Side Door Locking Rod Knob Assembly 1
Procedure 1. Lower window. 2. Ensure locking rod is in the unlocked position. 3. Use a flat-bladed tool to disengage detent tab and then remove knob by
MY Tuesday, April 07, 2009 4:48:29 PM
Page 11
© 2005 Mitchell Repair Information Company, LLC.
Thank you very much for your reading. Please Click Here Then Get More Information.