INTRODUCTION
ADDITIONAL REFERENCES Please refer to the other materials (operator’s manual, parts catalog, engine technical material and Hitachi training material etc.) in addition to this manual.
MANUAL COMPOSITION This manual consists the Technical Manual and the Workshop Manual. Information included in the Technical Manual: technical information needed for redelivery and delivery, operation and activation of all devices and systems, operational performance tests, and troubleshooting procedures.
Information included in the Workshop Manual: technical information needed for maintenance and repair of the machine, tools and devices needed for maintenance and repair, maintenance standards, and removal/installation and assemble/disassemble procedures.
PAGE NUMBER Each page has a number, located on the center lower part of the page, and each number contains the following information: Example : T 1-3-5 Consecutive Page Number for Each Group Group Number Section Number T: Technical Manual
W: Workshop Manual
IN-01
INTRODUCTION SAFETY ALERT SYMBOL AND HEADLINE NOTATIONS In this manual, the following safety alert symbol and signal words are used to alert the reader to the potential for personal injury of machine damage.
CAUTION: Indicated potentially hazardous situation which could, if not avoided, result in personal injury or death.
This is the safety alert symbol. When you see this symbol, be alert to the potential for personal injury. Never fail to follow the safety instructions prescribed along with the safety alert symbol. The safety alert symbol is also used to draw attention to component/part weights. To avoid injury and damage, be sure to use appropriate lifting techniques and equipment when lifting heavy parts.
IMPORTANT: Indicates a situation which, if not conformed to the instructions, could result in damage to the machine. NOTE: Indicates supplementary technical information or know-how.
UNITS USED Example : 24.5 MPa (250 kgf/cm2, 3560 psi)
SI Units (International System of Units) are used in this manual. MKSA system units and English units are also indicated in parenthheses just behind SI units.
Quantity Length Volume
Weight Force Torque
To Convert From mm mm L L m3 kg N N Nm Nm
Into in ft US gal US qt yd3 lb kgf lbf kgf m lbf ft
A table for conversion from SI units to other system units is shown below for reference purposees.
Multiply By 0.03937 0.003281 0.2642 1.057 1.308 2.205 0.10197 0.2248 0.10197 0.7375
Quantity Pressure Power Temperature Velocity Flow rate
IN-02
To Convert From MPa MPa kW kW C km/h min-1 L/min mL/rev
Into kgf/cm2 psi PS HP F mph rpm US gpm cc/rev
Multiply By 10.197 145.0 1.360 1.341 C 1.8+32 0.6214 1.0 0.2642 1.0
NOTE
GENERAL / Bleeding Air from Hydraulic Oil Tank 3. Remove socket bolt (2) of air breather cap (1) at one side to remove air breather cap (1). Remove filter (3). Wind an adhesive tape around bayonet assembly (4) approx. one and half turns so that the port is plugged. Reinstall filter (3) and air breather cap (1) to the original position. : 4 mm 4. Remove other side air breather cap (1). Connect a vacuum pump. Operate the vacuum pump continuously to create negative pressure in the hydraulic oil tank. Run the vacuum pump continuously while maintenance / repair period.
2 3 1 Port
4
5. After completing the maintenance / repair, be sure to remove the adhesive tape from bayonet assembly (4).
W118-02-05-001
W1-4-2
Thank you very much for your reading. Please Click Here Then Get More Information.