NEW FROM AEROFLOW

A range of new products have been introduced to the market by Aeroflow Since 2010, Aeroflow Performance Products has grown to design and manufacture close to 12,000 quality products. Amongst the latest releases are the following products.

Ford 9” 31-Spline 23” Cut to Fit Axle Kit

The Aeroflow Performance Ford nine-inch cut to fit axles are perfect for entry level users and will allow you to build your own custom width rear end easily. They are an induction heat treated forged 4140 steel construction axle with a natural finish and are sold as one axle only. Axle length is measured from the flange to the end of the splines. They are drilled for 5 on 4-1/2” and 5 on 4-3/4” wheel bolt patterns using 0.685” (17.39mm) knurl diameter for wheel studs 7/16” and 1/2” threads which are included.

GM LS1 to LS3 Knock Sensor Conversion Harness

The Aeroflow Performance GM LS knock sensor conversion harness allows for dual wire knock sensors to be plugged into the factory LS1 harness. It adapts from the one knock sensor on the LS1 and converts over to the dual LS3/LSX knock sensor system. Aeroflow notes that in order to use this you may require special PCM software changes or a PCM programmed for the use of dual wire knock sensors. The harness is made from OEM Delphi-Packard connectors with high temp cross-linked polyethylene TXL wire.

Bang Shift Holden VE-VF Commodore Shifter Drop Box

Aeroflow Performance shifter plates allow the installation of aftermarket shifters on top of the transmission tunnel or below the factory console and surround. Aeroflow notes these shifter plates/drop boxes are a universal design that may require modification to your console surround for best fitment depending on the model of vehicle and which shifter is being used. They are best suited for Ratchet shifters such as Bang Shift Pistol or Nitro as well as many other leading brands.

GM LS Rocker Arm Stands

The Aeroflow Performance Billet GM LS rocker arm mounting stands mount between the shaft and cylinder head for the correct rocker arm mounting position. These are constructed from 7075 billet aluminium to ensure longevity, while also reinforcing them for more rigidity in high-horsepower and boosted applications. These bars are designed to help with rocker arm control and cut back on flex and distortion that is imposed from the valvetrain. Bars will fit stock and aftermarket LS3 heads but if these are used on OEM cylinder heads not all casting are the same and they may require some slight modifications. When installing these ensure to check rocker geometry and pushrod length. Sold as a pair. For more information, visit www.aeroflowperformance.com