12/02/2010
How to Cover Electrical Wall Plates with Wallpaper http://electricwallplates.net
Step 1 Hold a piece of wallpaper over the light j the pposition of the ppaper p switch. Adjust until the pattern on it matches the pattern on the surrounding wall. Using your pencil, mark the paper just outside each corner of the switch plate, which you should be able to see or feel behind the paper. Make the marks deep enough that they will be visible from the other side of the wallpaper.
1
12/02/2010
Step 2 Turn off the power to the switch at the fuse box. box Unscrew the switch plate. plate Make sure to remember where you put the screws.
Step 3 Lay your marked piece of wallpaper on thick cardboard, face side down. Lay the switch plate on top of the paper, face side down, positioned with corner marks you made. With your pencil and straight-edge, draw a roughly half-inch border around the outer edge of the switch plate. Then trace the inside of the square switch hole, making your lines just a little smaller than the hole. Draw circles where the screw holes are.
2
12/02/2010
Step 4 Remove the switch plate and use your razor knife to cut out the border you you've ve drawn and the hole for the switch plate. For each circle where the screw holes go, carve a very small X (no wider than the width of the hole).
Step 5 Brush wallpaper adhesive around the front and thin side edges of the socket plate. With the wallpaper piece lying face-down, lay the plate face-down on it, aligning the switch holes and the X's at the screw holes. Press to adhere the glue. Turn the plate over and smooth the paper around the edges and inside the switch hole. Turn it back over and use small pieces of masking tape to hold the wallpaper flaps to the back of the plate.
3
12/02/2010
Step 6 Replace the plate on the switch. Push the screws through the X X'ss you made over the screw holes.Turn the power back on.
Thank You http://electricwallplates.net
Source: http://www.ehow.com/how_5139372_cover-electrical-wall-plates-wallpaper.html
4