FT-30 pen From birth to slaughter
■ Very flexible; can be used from birthg to slaughter ■ Less transportatiom of pigs, less stress, better growth ■ Very suitable for production of welfare pigs ■ Extra large creep box, place for up to 25-30 kg’s pigs ■ Transparent cover in the creep box - easy to monitor the piglets from outside ■ Height-regulated barrier plate in the creep box
Danish Design I German Quality I Global Experience
I FT-30 pen I Many years of experience for loose sows...
The FT-30 pen was modelled based on the Norwegian solution for loose nursing sows. The result is a very flexible pen that can be used from birth to slaughter. By applying the birth to slaughter system you avoid many transfers of the pigs, which means a lot less cleaning in comparison to traditional production. At the same time you save the pigs from stress, which gives a better daily gain and feed conversion. The pen is designed with a transparent lid, so that you can see the piglets without entering the pen. The large creep box can be used for piglets up to 25-30 kg. The pen is particularly well suited for special production of welfare pigs.
The handle is used to regulate the barrier plate’s height.
Subject to changes in materials and design reserved.
ACO FUNKI A/S KirkevĂŚnget 5 DK-7400 Herning T. +45 9711 9600 www.acofunki.com www.egebjerg.com
FT-30 PEN - FACTS Pen length
320-340 cm
Pen width
240 cm
U-profiles, casting
2 mm stainless
Creep box, width
110 cm
Creep box, area
1 m2
The FT-30 pen can be constructed in 35 mm board profiles or 10 mm fiber plates. Dimensions
Board profile
Fiber plate
SIde part height
100 cm
96 cm
Rear part height
75 / 100 cm
75 / 96 cm
Gate height
100 cm
96 cm
SS bars height
100 cm
96 cm
The FT-30 pen can be made of 10 mm fiber plates.
B-6501-GB