Re-install mach3 manual Please un-install mach3 in your PC, then can continue with this manual
1.
2. All click “next� and do not change anything
find the “mach3” file in “C ”disk in your PC F d in
t
If it is CNC router machine, please copy the “mach3mill.xml” file to “mach3”file in “c” disk If it is CNC plasma machine, please copy the “plasma.xml”to “mach3”file in “c” disk
click:yes:
5.对刀的安装： M930.m1s 拷贝到 MACH3 安装目录 c：\Mach3\macros\Mach3Mill 下.
Tool calibration ‘s installation : Copy the “M930.xml” file to root“Mach3\macros\Mach3Mill”
copy
然后打开 mach3 软件,在“Config”配置菜单下,选择”ports and 修改后点击应用，确定。·
to
pins”配置插件.，然后按照下图
Then open the :config:, choose “ports and pins”, then following below picture, then click “确定”
6. 手轮的安装 在 MACH3 安装目录下有个 “PlugIns” 文件夹,如果没有请建一个名为”PlugIns”的文件夹.然 后把驱动文件 ShuttlePro.dll 拷贝到此文件夹\Mach3\PlugIns 下. Wireless remote’s installation : There is a file named “plugIns”file in mach3’s installation file, if there is not such file, please build up a file named”plugIns”, then copy the “ShuttlePro.dll” to “mach3/PlugIns”
copy
to
然后打开 mach3 软件,在“Config”配置菜单下,选择”Config Plugins”配置插件.在弹出的配置插 件窗口中,将” ShuttlePro-XHC-FOR-MACH3…”enable 使能,这时会看到到有绿色的钩. Then optn “config”, choose “config PlugIns”, and get “ShuttlePro-XHC-FOR-MACH3…”, Make it enable, then you will see the green mark as below.
Then，点击 Reset Then click”RESET”
键
特别注意：如果使用 手轮请点击如上，如果不使用 请点击 Please note : if use the wireless handle, please click as below
If do not use the wireless handle, please make as below
关闭。
7.雕刻机点击桌面图标： For CNC router, click above
等离子点击桌面图标：
For CNC plasma , click above