Cerus Industrial Warranty Claim Form NOTE: This form must be completed for Warranty Claims. Form is to be complete - an incomplete form may invalidate the warranty. This form is to be used by 503-643-4925 or mailed to Cerus Ind., 22995 NW Evergreen Pkwy, Hillsboro, OR 97124. It may be downloaded (www.cerusind.com/dealertools) and emailed to techsupport@cerusindustrial.com VFD
Part # Serial # Date in Service
PANEL
(If Apllicable)
Panel Part # Panel Job #
INSTALLATION INFORMATION
DESCRIPTION OF PROBLEM
Motor Data
VFD Powers Up?
Insulation Class/Rated Voltage
VFD Runs Motor? Details:
Ins.
/
V
HP/ SF/
Horsepower/Full Load Amperage Service Factor/RPM
FLA RPM
YES YES
NO NO
Application Torque Input phase
constant
variable
three phase
single phase
Description (i.e. pump jack, centrifuge, fan, blower, etc.)
Maximum & Minimum Environmental Temperature Max: Distances in feet from VFD
째F
째F
Min:
to service transformer
to motor
Startup information
( example: sleep mode, acceleration, etc...)
Check proper wiring & grounding Input Voltage on VFD terminals R, S, & T VFD Output Current Parameter Reading @ Max Speed Speed control
YES R-S
S-T
R-T
(see manual
Amps for parameter) Keypad Potentiometer
0-10V 4-20mA Please note any drive alarms or faults: PID
Communication Card
Were VFD parameters set according to quick start guide? Environmental Conditions
(Please select all applicable conditions)
VFD enclosed by?
Problem occurs under what condition?
YES
NO
Indoor Outdoor Direct Sunlight Cerus
Customer
Dirt/Debris Moisture Chemicals Not Enclosed Enclosure NEMA rating
A
E
B
Lightning Arrestor
C
D
Input Line Reactor
Motor Disconnect / Contactor Aux.
H
Output Reactor Motor Guard Filter
EFI/RFI Filter
4 or 4X D (BTU)
I G
F
12 W
(In.) / AC
Variable Frequency Drive
Harmonic Filter Input Contactor
3R H
Enclosure dimensions in inches Cooling Fan/AC Unit Size Fan
package that was not built by Cerus Industrial.
Short Circuit Protection Power and Disconnect Source
1
Motor
J
Motor Disconnect / Contactor
Model Number of Dynamic Brake Unit / Resistor
Installed Devices
(Indicate the letters of installed devices shown in diagram above. i.e., A, B, D, F)
(if applicable)
INSTALLER INFORMATION Name Email Company/Address
Installation date
/ Resistor
DB Unit
PURCHASER PURCHASERINFORMATION INFORMATION Phone Fax
Install Location
Name Email Company/Address
Purchase date
Phone Fax
PO#
Failure to complete this form may delay warranty processing.