FEATURES | 52
The emergency stop switch will stop the engine when the lanyard is pulled
TOWER (Tower Lights)
far enough to disconnect the clip from the switch. Attach the lanyard to the
This switch operates the tower lights. When the switch is pressed on, the lights
boat operator whenever the engine is running, but be aware of loss of engine
will turn on. When the switch is pressed off, then the lights will turn off.
power if the switch is activated.
Horn If the operator is thrown from the seat, or moves too far from the dash, the
The “HORN” button is a momentary switch. The horn will operate when the but-
lanyard will disconnect the clip from the switch, shutting off the engine.
ton is pressed and stop when the button is released.
To attach a lanyard, connect the clip to the emergency stop switch and
Ignition Key Switch
the hook to a strong piece of clothing on the operator, such as a belt loop.
This key switch starts and stops the engine. A built-in protection system prevents the engine from starting in any gear and only in NEUTRAL. Refer to Shifter/
IMPORTANT
Throttle Control in this section and refer to the engine owner’s manual for more
The engine will not start unless the clip is attached to the emergency
information.
stop switch. There is an accessory position on the ignition key switch. A terminal on the back The emergency stop switch can only be effective when it is in good working condition.
of the switch is provided to control power to add-on accessories. Even though power to this terminal is protected by a 20-amp fuse, do not connect any accessory that draws more than 10 amps. Attaching an accessory to this terminal
Observe the following:
should only be done by a qualified technician.
• DO NOT remove or modify an emergency stop switch and/or its lanyard. • Keep the lanyard free from obstructions that could interfere with
NOTICE
its operation. Check the emergency stop switch once a month for proper operation. With the
DO NOT connect an accessory drawing more than 10 amps to the key
engine running, pull lanyard to pull the clip from the switch. If the engine does
switch accessory terminal. A hazardous situation or damage to the electri-
not stop, see your ATX Dealer for service immediately.
cal system can occur.
