3 minute read

Advertorial:Innovative workshop heating

SAVE MONEY WITH PULS-AIR – WORKSHOP AND HALL HEATING

Enjoy 50% less heating costs, thanks to innovative workshop heating from Austria

Inflation and price increases in all sectors have caused heating costs to rise sharply for many workshops and halls. With the heaters from the Austrian manufacturer Puls-air, heating costs can be reduced.

What is Puls-air?

Puls-air is an oil-powered warm air heater for workshops and halls. Halls up to 1,800 m³ (with very good insulation) can be heated with one unit. For larger premises, several units can be used in combination. The commissioning of Puls-air is very simple and no separate chimney is necessary.

How does Puls-air work?

The patented pulsating combustion with an e ciency of 97 % is installed. This means that almost all the fuel supplied is converted into heat. Pulsating combustion originally comes from rocket research and has been used by Puls-air to heat workshops for over 30 years.

Why is Puls-air so economical?

Firstly, because of the already mentioned patented pulsating combustion with 97 % e ciency. During combustion, an oscillating gas column is created that changes direction 63 times a second. Movement = heat. This heat is used to heat the workshops and halls. The second reason is the physically optimal positioning on the floor of the room to be heated. The warm air is released where work is being done, distributes itself in the floor area and then slowly rises, cools at the top, sinks again and is drawn back through the unit preheated. A slowly rotating thermal air roll is created, the entire room is heated evenly and quickly.

Most Puls-air customers report heating cost savings of more than 50 % compared to ceiling fans, radiators, etc.

Clean combustion, quiet operation

The pulsating combustion achieves excellent exhaust gas values (NOX - 25 - 30, CO - 2 - 5 ppm; soot number 00). The running noise of the innovative heater from Austria is low at 57 dB.

Easy commissioning (plug and play)

The commissioning of Puls-air is very simple and consists of 3 main steps:

1) Place the unit in the room to be heated

2) Plug in 230 volt power

3) Conduct the exhaust gas via a 35 mm stainless steel pipe over the roof into the open air.

DONE. The manufacturer also recommends connecting the unit to a larger heating oil tank via an 8 mm copper pipe and a non-return valve. Thanks to the 20-litre tank supplied, the heating system is immediately ready for operation.

Delivery time, order and advice

In order to avoid delivery bottlenecks, we recommend that you place your order as soon as possible. Puls-air will be happy to advise you by telephone or e-mail in German and English. Orders can be placed online at www.pulsair.net

info@pulsair.net

This article is from: