®
Clinical Checklist: Final Impressions-Lower
By Global Dental Science LLC
1. Make PVS cast from existing denture.
7. Trim stops not to interfere with border molding material.
2. Choose correct size tray. Place tray in hot water (160º-170º farenheit) for 60 seconds until tray is malleable.
8. Express AvaDent Border Molding material along entire edge of prepared border, then cover entire tray.
3.
Thermo-form trays to PVS cast. 9.
4.
depth.
Insert tray into mouth and perform border movements then inspect impressions for tray exposures and overall quality, correct if necessary.
Trim trays borders 2mm short of border
5. Apply adhesive to tray.
6. Using AvaDent Bite Registration material, place stops in impression tray.
= This quality control check alerts you to critical steps required to minimize potential error in your AvaDent Digital Record and Final AvaDent.
10. Apply light body AvaDent Impression material wash sufficient to complete final impression.
11.
Insert tray into mouth and perform border movements.
12.
Inspect impressions for tray exposures and overall quality, correct if necessary.
©2014 Global Dental Science LLC. AvaDent® is a registered trademark of Global Dental Science.
Clinical_Checklist_FoF_Impressions_v.5
®
Clinical Checklist: Final Impressions-Upper
By Global Dental Science LLC
1. Make PVS cast from existing denture.
7. Trim stops not to interfere with border molding material.
2. Choose correct size tray. Place tray in hot water (160º-170º farenheit) for 60 seconds until tray is malleable.
8. Express AvaDent Border Molding material along entire edge of prepared border, then cover entire tray.
3.
4.
Thermo-form trays to PVS cast.
Trim trays borders 2mm short of border depth.
5. Apply adhesive to tray.
6. Using AvaDent Bite Registration material, place stops in impression tray.
= This quality control check alerts you to critical steps required to minimize potential error in your AvaDent Digital Record and Final AvaDent.
9.
Insert tray into mouth and perform border movements then inspect impressions for tray exposures and overall quality. Correct if necessary.
10. Apply light body AvaDent Impression material wash sufficient to complete final impression.
11.
Insert tray into mouth and perform border movements.
12.
Inspect impressions for tray exposures and overall quality. Correct if necessary.
©2013 Global Dental Science LLC. AvaDent is a registered trademark of Global Dental Science.
Clinical_Checklist_FoF_Impressions_v.5