==== ==== For more information, as well as deeply discouned home networking products, please click this link. http://bit.ly/wHLCla ==== ====
The average American home has three computers typically one older desktop computer and two newer laptops. In the typical household set-up, the old desktop computer is located close to the phone jack or cable outlet that hooks it to the internet, and the family's printer rests near the old desktop PC, where it was installed years ago, because it seemed convenient at the time. Unless the family installs a home network, laptop users forfeit their internet access and their printing privileges...or you run crazy spaghetti-like tangles of wires and cables and splicers and splitters from the bedrooms to that one sadly overloaded desktop link. For less than $50 (US), you can install a home wireless network that links all the household computers to the World Wide Web and essential peripherals. A wireless router is a key element, the "hub" of a home network. Available at "big box" electronics stores and most major retailers, a wireless network router typically comes with everything you need for installation and set-up, but you may need extra Ethernet or coaxial cables to link the separate pieces in your network modem, router, and computer. Wireless laptops in remote locations will connect via the radio signals from your router, and you will configure each of them individually after you have set-up the basics in your network. Both common sense and reasonable caution should prevail as you configure each piece and connect the links in the daisy chain that comprises your home network. If you already have internet access via your service provider's modem, you simply install your new wireless router "between" the modem and your main computer. Your router almost inevitably came equipped with an installation wizard on a CD, and using the wizard gives you the quickest, safest, and easiest way to configure the three essentials in your network. When modem, router, and computer are linked and recognizing one another, follow the wizard's instructions mostly you will click "next" when the user interface prompts you. There are certain IP addresses which are set up by the factory as defaults. The IPs 192.168.0.1 and 192.168.2.1 are two of them. The IP address 192.168.1.254 is default for certain home based broadband routers and modems. These include Linksys SRW2024 range switches, some 3Com OfficeConnect routers and ADSL routers from Billion. Though this is set at the factory, it can be changed using the software provided by the vendor for the management of the hardware and software associated. 192.168.1.254 is a IPv4 (private) network address. Though, any device on a local network can use it, only one device on that network should be using this address at a time. This is true of any IP address and is necessary to avoid IP address conflicts. 192.168.1.100 marks the beginning of the default dynamic IP range for the home network routers from Linksys. Thus, DHCP will assign the address 192.168.1.100 to the first device that's attached to a Linksys router. You can use the set up utility of the router to either use it or not. Also, because
this IP address is a private IP address, you can assign it manually to a device on your local network. But don't use it on a local device if it's in the DHCP range.
If you'd like to find out more information about setting up a home network, please read about 192.168.1.254 and 192.168.1.100.
Article Source: http://EzineArticles.com/?expert=George_Faith
==== ==== For more information, as well as deeply discouned home networking products, please click this link. http://bit.ly/wHLCla ==== ====