CT-4035 UAV Man Pack type Anti-Drone UAV jamming system
User manual
1
Foreword This manual is the operating instructions of the CT-4035 UAV jammer (referred to as the “unit” in this manual). CT-4035 UAV is a jamming device intended to prevent all Drone UAVs. The unit outputs 2-40W for each of the Five bands 2400-2500MHz: 20W, 5.7-5.9GHz, GPS L1 1570-1620MHz: 40W, 2400-2500MHz, and 2400-2500MHz (Option 433MHz, 860-920MHz or GPS L2, GPS L5)
Safety guidelines Read the following guidelines before using the unit. may be dangerous or illegal.
Failure to comply with these guidelines
In any event of doubt, consult your local distributor or Vendor’s
support staff before use. Handling and transportation Take maximum care while handling the unit. Environmental conditions Do not place the unit near heat sources.
The unit dissipates a lot of heat.
ventilation holes and do not insert any objects through them.
Never block its
Always allow at least 10 cm
clearance in front of ventilation holes on two sides for free air circulation
Qualified service Only trained service personnel qualified by Vendor are allowed to diagnose and maintain the unit in accordance with established safety practices and standards.
2
Features Jamming frequency
2400MHz – 2500MHz:20W WiFi
5.7GHz – 5.9GHz : 2W
GPS L1 1570-1620MHz :40W
2400MHz –2500MHz:20W
2400MHz-21500MHz WiFi :20W (Omni Anteenna)
( Option 433MHz, 860-920MHz or GPS L2, GPS L5) Four bands in One Directional Antenna
Electrical
Specifications
Frequency Range
1575-1620MHz
2400-2500MHz
2400-2500MHz
5150-5875MHz
Gain
8dBi
12dBi
12dBi
15dBi
VSWR
≤1.5
≤1.5
≤1.5
≤1.5
Polarization
Vertical
Vertical
Horizontal
Vertical
Horizontal beamwidth
65°
65°
65°
60°
Vertical beamwidth
30°
15°
15°
7°
Front to back ratio
≥24dB
≥25dB
≥25dB
≥25dB
Input Impedance
50Ω
50Ω
50Ω
50Ω
Max Input Power
50W
50W
50W
50W
2400-2500MHz cover both Vertical and Horizontal Polarization One 2400-2500MHz Omni antenna to cover 360 degree Good Isolation each other (4 bands in) Connector
N-M
Lightning protection
Direct Ground
Mechanical Specifications Dimensions
255*255*45mm
Weight
1.1kg
Radiator Material
Alumina
Radome Material
Black
Omni antennas (5-6dBi) 2400-2500MHz Internal Li-FePO04 rechargeable battery (24V/ 20AH，can recharge 1500 times), supporting 1-2 hrs (if you need more operating hours, please contact us).
The Conditions in the system are indicated by the LEDs. The input power applied from 110V or 220V AC. 3
General Description
CT-4035 Jammer
4 in 1 Directional antenna + Omni Antenna
Main Power Switch
***NOTE***: Before you turn on the jammer, please……….. Make sure connect all Antennas to the4 jammer
+24V/10A Battery Charger
Quick Installation: Step 1: Connect all antennas to the Same Number Bands…
GPS L1
2400-2500MH z
5.7-5.9GHz
5
2400-2500MH
2400-2500MH
Step 2: Turn Both “ Main Power”
ON…….
Jammer’s Five Bands Modules Each Band has the Output Power Switch from 0 to Max Step 1: Switch ON each band Clockwise to Max
Step 3: Turn Each Band “ ON “…….
6
Charging Use Battery Charge to charge the CT-4035 UAV Jammer When battery is low, plug the Battery AC cable, one side to Charging In another side to AC 110 or 220V. U
U
The LED of Charging (Red) will turn on , device is in charging state. U
U
AC 110 or 220V
After about 2-4 Hours, Battery is 25AH and Charger is 10A. Charger Indicator will become “ Green”, indicating the battery had been 95% charged.
LED is Red when the battery is charging Battery need 60-90 minutes to Full AC 110 or 220V
BAT. Full
LED is Green when the battery is full charging
AC 110 or 220V
7
Notice: According to the feature of battery, please follow below rules. 1. This device support using while charging under one condition: Before charging, please turn off the device first. Just turn on the device after charging LED turns on. 2. The best way is fully charging after every use.
8