CT-6067 Series Pelican jamming system
User manual
1
Foreword This manual is the operating instructions of the CT-6067 Series Jammer (referred to as the “unit” in this manual).
The unit outputs 15-100W for each of the 6 bands 1570-1620MHz,
2400-2500MHz, 433MHz, 5700-5900MHz, 865-920MHz, 1220-1260MHz
Safety guidelines Read the following guidelines before using the unit. guidelines may be dangerous or illegal.
Failure to comply with these
In any event of doubt, consult your local
distributor or Vendor’s support staff before use. Handling and transportation Take maximum care while handling the unit. Environmental conditions Do not place the unit near heat sources.
The unit dissipates a lot of heat.
block its ventilation holes and do not insert any objects through them.
Never
Always
allow at least 10 cm clearance in front of ventilation holes on two sides for free air circulation Qualified service Only trained service personnel qualified by Vendor are allowed to diagnose and maintain the unit in accordance with established safety practices and standards.
Features Jamming frequency
CH1: 1570MHz-1620MHz 100W
CH2: 24000MHz-2500MHz 100W
CH3: 433MHz 100W
CH4: 5700MHz – 5900MHz 15W
CH5: 860MHz – 920MHz:100W
CH6: 1220MHz – 1260MHz :100W
The unit has output power for 100W for each of Five bands and 5.8GHz is 15W Omni antennas (3-8dBi).
2
The Conditions in the system are indicated by the LEDs. The input power applied from 110V or 220V AC.
General Description
6 Omni Antnnas Power Adapter
Main Power Switch
Antenna’s Cable
AC Power Adaper
External Battery
Power Switch All Dins Down…Max Output Power
AC 110-240V Power Cable 3
***NOTE***: Before you turn on the jammer, please……….. Make sure connect all Antennas to the jammer
Quick Installation: Step 1: Connect all antennas to the Same CH Bands…CH1 to CH1….
CH4: 5800MHz
CH3: 433MHz
CH2: 2400MHz CH5: 868MHz
CH1: GPS L1 MHz CH6: GPS L2 MHz
CH5: 868MHz
CH3: 433MHz
CH1: 1575MHz
CH6: 1220MHz
CH4: 5800MHz
CH2: 2400MHz
4
Step 2: Turn “ Main Power” ON Step 2: Switch ON on Main Power after you connect all Antennas to the Jammer
Step 3: Turn Each Band “ ON “…….
Step 3: Switch ON Each Band
Step 4: Turn Each Band Output Power to MAX… ALL Dins DOWN to MAX. Power Switch All Dins Down…Max Output Power
5
External Battery Options: B-50AH
AC 220V Power Cord for Charging
Connect to Jammer
Main Siwtch
Battery LED Status
Battery AH Percent Left
Battery AH Left
Estimated Working Time Left
Current Battery Vlotage
The Jammer work Current Amp
6