WITH APPENDIX A, QUIC PASS PROCEDURES 5/1/07
SWG0C
SWG0C
SWG01
SWG02
SWG03
SWG04
SWG05
SWG06
SWG07
SWG08
SWG09
SWG10
SWG11
SWG12
SWG13
SWG14
SWG15
SWG16
SWG17
SWG18
SWG19
SWG20
SWG21
SWG22
SWG23
SWG24
SWG25
SWG26
SWG27
SWG28
SWG29
SWG30
SWG31
SWG32
SWG33
SWG34
SWG35
SWG36
SWG37
SWG38
SWG39
SWG40
SWG41
SWG42
SWG43
SWG44
APPENDIX A, PAGE 1, QUIC PASS
QUIC-PASS DIE AND SLEEVES
QUIC-PASS USES STD S-505 SLEEVES WITH SPECIAL DIES NOTED IN THE TABLE ABOVE DIES ARE AVAILABLE FOR UP TO 1 ½” WIRE ROPE SIZE
APPENDIX A, PAGE 2, QUIC PASS
QUIC-PASS AND THE FLEMISH EYE
THE FINISHED SLEEVE HAS A “HEX” APPEARANCE THAT PROVIDES A QUIC-CHECK LOOK TO DETERMINE IF THE TERMINATION HAS BEEN SWAGED AND PROVIDES A FLAT SURFACE THAT ALLOWS FOR EASE OF I.D. STAMPING ON THE FINISHED SLEEVE
THE FLEMISH EYE FOR QUIC-PASS SYSTEM IS FORMED THE SAME AS WITH STANDARD ROUND SLEEVES
APPENDIX A, PAGE 3, QUIC PASS
QUIC-PASS AND SWAGING
FLASHING IS NOT AN ISSUE WITH QUIC-PASS SYSTEM EACH PASS REQUIRES THE FULL CLOSURE OF THE DIES THE CAVITY IS DESIGNED TO ALLOW SWAGING WITH OUT PULLING A FLASH
APPENDIX A, PAGE 4, QUIC PASS
APPENDIX A, PAGE 5, QUIC PASS