Bringing out of storage ●
Check oil level in the engine and drive/reverse gear. Top up if necessary. If there is inhibiting oil in the system drain and fill with new oil, change oil filter. For correct oil grade: See the chapter ”Technical Data”.
●
Drain the antifreeze from the seawater system.
●
Install the impeller in the seawater pump (replace if the old one looks worn).
●
Close/tighten drain cocks/plugs.
● ●
●
●
50
●
Paint the drive and hull: See next page.
●
Check the sacrificial anode on the drive. If there is less than 50% of the anode left it must be replaced. Clean with emery cloth just before the boat is launched. IMPORTANT! Do not use a wire brush or other steel tools when cleaning, as these may damage the galvanic protection.
●
Reinstall the propeller.
●
Launch the boat. Check for leaks.
Check the condition of rubber hoses and tighten hose clamps.
●
Vent and lubricate the propeller shaft seal (reverse gear).
Check engine coolant level and antifreeze protection. Top up if necessary.
●
Start the engine. Check that there are no fuel, engine coolant or exhaust gas leaks and that all control functions are operating.
Check drive belts.
Connect the fully charged batteries.
