362-939

Page 1

HW-HIFC -10-2

Remote Power Panel L U T R O N

S P E C I F I C A T I O N

Job Name

S U B M I T T A L

Job Number

Location

High Inductance Filter Chokes

Model No. HW-HIFC-10-2

Overview

Top of panel with one installed HW-HIFC-10-2 shown

The HW-HIFC-10-2 assembly contains two 10A chokes that are designed to mount into an HW-PNL8 panel. The assembly uses DIN Rail terminal blocks to introduce the chokes in series with a load, typically to reduce lamp buzzing or improve electronic low-voltage dimming. Two 10A chokes may be placed in parallel for loads greater than 10 Amps. Each HW-PNL8 panel can hold two HWHIFC-10-2 choke assemblies.

Location for possible second HW-HIFC-10-2

DH 1 DH 2

Specifications

Chokes Per Assembly 2 Assemblies Per Panel 2 Current Capacity 10 Amps, 2 chokes may be connected in parallel for up to 20 Amps capacity Mounting Inside HW-PNL8 Environmental 32°-104°F (0-40°C) Current Rise Time 320 microseconds or greater, measured from 10% to 90% of total current rise for a 1250W load at 90% conduction. Current rise time shall be 315 microseconds or greater for a 650W load at 90% conduction. At any point on the waveform, the current rise time shall not exceed 45 milliamperes per microsecond with a 1250W load, or 30 milliamperes per microsecond with a 650W load.

Lutron Electronics Co., Inc. 7200 Suter Road Coopersburg, PA 18036, USA 9/96 P/N 362-939

For additional submittal sheets, call our Hot Line and Fax-on-Demand Service at 1-800-523-9466, or visit Lutron’s Web site at http://www.lutron.com/resi


Overview of HomeWorks Integrated System Preferred Feed and Load Wiring Entry

Local Vareo Dimmers/Switches - 12 buses available, with capacity of 4 dimmers/switches per bus

Optional High Inductance Filter Choke Locations

Vareo controls can switch or dim zone lighting and override programmed settings

Terminal Blocks handle 8 Remote Power Modules (RPMs), with capacity of 4 Lighting Zones Per Module

(Typical of 12 buses)

Master Keypads - 32 keypads maximum with 16 unique addresses possible

RPM Module Locations (8 Maximum Per Panel)

To next panel (Max. 8 Panels)

Master keypads can select pre-programmed lighting scenes, control pathways of light, raise or lower lights, and activate motor driven accessories

Interpanel Link

GRAFIK Eye System - Up to 8 GRAFIK Eye 3100 series controls per panel, with a maximum of 15 accessory controls

HW-LVOC-8 Low Voltage Relay Card Location HW-MA-8-120 Microprocessor Assembly Location Alternate Load Wiring Entries

Control Wiring Entry (Class 2)

Overview of HomeWorks Integrated System For loads less than or equal to 10 Amps:

For loads greater than 10 Amps (but less than 16 Amps): Wire Dimmed Hot to one side of both chokes, then the other side of both chokes to the load.

Red

HIFC Terminal Blocks 5 Position Bypass Jumper

Red

HIFC Terminal Blocks 5 Position Bypass Jumper

DH

Load

DH

Torque from 3.5 to 5 in-lbs.

DH DH

Red

DH

DH

DH

DH

H N N N N N

H

Black

Loads White

Torque from 3.5 to 5 in-lbs.

N N N N N

Red

Black

White

Warranty Lutron will, at its option, repair or replace any control that is defective in materials or manufacture within two years after the purchase. This warranty is in lieu of any other warranties, express or implied, and the implied warranty of merchantability is limited to two years from purchase. This warranty does not cover the cost of installation, removal or reinstallation, or damage resulting from misuse, abuse, or improper wiring or insulation. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty may last, so the above limitations and exclusions may not apply to you. Š 1996 Lutron Electronics Co., Inc.

Printed in U.S.A.


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.