wall thickness variable
insulation thickness variable
wall construction adhesive mortar min. 60% surface percentage insulation material priming render 1st step reinforcing mesh in the upper third anchors for the insulation material (dowelled through the mesh) anchor plate anchor sleeve priming render 2nd step applied wet-on-wet optionally only level out the anchor heads laying mortar about 3 mm Feldhaus thin bricks 9 or 14 mm jointing mortar
sealing according to DIN 18195 system-related bonding on sealing
gradient of the water bearing layer > 2%
>= 150 mm
>= 300 mm
system-related sealing slurries to be raised about 10 cm behind the thin bricks on the reinforcement, in the front up to ground level
minimum height of sealing
if applicable dowelling according to specifications of system manufacturer
splash water areas
plinth plate, min. 300 mm above top level of balcony covering
roof sealing according to flat roof guideline
Feldhaus Klinker Vertriebs-GmbH Nordring 1, 49196 Bad Laer Zentrale +49 (0) 54 24 29 20 0
Note: This detail is a general proposition which schematically shows a possible execution. Usability and completeness are to be checked under personal responsability regarding the particular construction project.
www.feldhaus-klinker.de
Related works are only shown schematically. Content The specifications of corresponding standards, relevant system authorisations and data sheets are to be respected. All specifications and assumptions are to be customised to local conditions.
balcony connection to thin bricks vertical cut
M
1:5
sheet FH_EN_V_thinbr-balcony-1 date
03.10.2018