wall thickness variable
insulation thickness variable
wall construction adhesive mortar min. 60% surface percentage insulation material priming render 1st step reinforcing mesh in the upper third anchors for the insulation material (dowelled through the mesh) anchor plate anchor sleeve priming render 2nd step applied wet-on-wet optionally only level out the anchor heads finishing render and optionally painting
joint sealing tape plinth profile trowel cut or rendering strip system-related joint sealant backfill material (PE-round cord)
system-related bonding on sealing plinth plate, min. 300 mm above ground level
>= 300 mm
Feldhaus thin bricks 9 or 14 mm sealing according to DIN 18195
splash water areas
if applicable dowelling according to specifications of system manufacturer
system-related sealing slurries to be raised about 10 cm behind the thin bricks on the reinforcement, in the front up to ground level
gradient
dimpled sheet with fleece anti-capillary, water drainage layer, such as gravel (pointed protective strip with drainage according to DIN 4095)
Feldhaus Klinker Vertriebs-GmbH Nordring 1, 49196 Bad Laer Zentrale +49 (0) 54 24 29 20 0
Note: This detail is a general proposition which schematically shows a possible execution. Usability and completeness are to be checked under personal responsability regarding the particular construction project.
www.feldhaus-klinker.de
Related works are only shown schematically. Content The specifications of corresponding standards, relevant system authorisations and data sheets are to be respected. All specifications and assumptions are to be customised to local conditions.
plinth of thin bricks 3 with offset, main facade render vertical cut
M
1:5
sheet FH_EN_V_thinbr-plinth-3 date
03.10.2018