1 Top Corners
3 Check bottom corners
5 Middle Layer
The procedure may need repeating as it cycles through the patterns.
Getting the top corners is easy and learning to do it yourself is best as it gives a better understanding of the cube. The same goes for the whole of the top layer but here are the solutions for the edge cubies to help you on your way.
Check the bottom corners are lined up all the way round, do the following if two corners need swapping over.
2 Top Edges B to X Centre Bottom Centre C to X Front Middle Front D to X Middle Front Middle Front E to X Middle Front Middle Front Copyright G. Kirkby 01/06/2014
6 Rotate Final Edge Pieces.
Right Bottom Right Bottom Front Bottom Front
Keeping the cube upside down so the completed side is on the bottom hold the cubies to be moved to the right and not to your front. “A” moves the cubie towards you.
Right Top Right Top 4 To rotate bottom corners Right Turn the cube upside down and hold in this Top position. If this pattern does not exist, then keep Right the far left corner blank or two matching colours on Top the left hand side as the case may be. Repeat as Right necessary.
CENTRE Front Top Front CENTRE Front Top Front 7 Move Final Edge Pieces Hold the good side to the back.
“B” moves the cubie away from you.
Right Top Right Top Right Top Right Top
Right Top Right Top Right Top Right Top Right
Front Top Left Right Front Left Right Top Front
Front Top Right Left Front Right Left Top Front