EF/EC/1-2/0.2 ELECTRONIC EDGE FINDER FEATURES An easy, accurate & time saving tool for precisely locating work edges, shoulders, grooves etc. for use on both conventional & CNC equipment Edge finder lights instantly when the stylus touches the work edge. Designed with 6 equally spaced light ports for visibility from any angle
CAP BATTERY SPRING
12V BATTERY
SHANK (½'' DIA.)
Reads off any electrically conductive metal Head Type: Cylindrical 0.20” dia. Shank Dia: ½” Repeatability : 0.0002” Furnished with LED , 12V Battery & protective case
LIGHT PORTS(6) HEAD/STYLUS (0.20''DIA CYLINDER)
DIRECTIONS Open the Edge Finder Cap & install the12 V battery inside. Insert the Battery Spring & then close the Cap Insert the shank of the Electronic Edge Finder into the ½” Chuck or collet and carefully traverse machine table to gently contact the work-piece As soon as stylus of the Electronic Edge Finder touches the workpiece (must be electrically conducive metal), the light will go on. With the light glowing on, set your micrometer on the machine to zero. Move the table to disconnect the edge finder from the work-piece. Once again traverse the table to gently make contact. As soon as the edge finder lights, stop & re-check micrometer reading. It should be zero Remember the Head / Stylus is 0.200” & calculate accordingly When the light becomes faint, replace battery first , if problem persists , re-adjust Battery Spring to make good contact
WARNING: Do not run machine while using this Edge finder! S1210, Rev A