Jaipur Arbour
ROWLINSON GARDEN PRODUCTS LIMITED Green Lane Wardle, Nr. Nantwich Cheshire CW5 6BN Help Line (Normal Office Hours) 01829 261 121
English SS100D
Assembly Instructions 1. Seat to uprights
4. Roof rafter Assembly
Drill four holes in each seat slat bearer as shown in the diagram. Position the seat between the two uprights, 360mm from the bottom of the upright. Secure through the drilled holes into the upright legs using 8 x 70mm screws.
Secure the ends of 2 roof rafters together using an L-bracket fixed to the underside of the rafters with 4 x 40mm screws as shown below. Repeat with the remaining 2 rafters. Drill 4 holes in all the finials as shown.
Drill
Drill
70mm
40mm
Drill
Drill
5. Roof rafters to uprights
Seat slat bearer 360mm
Before assembly
Sit a rafter onto the front rebates of the uprights. Secure 2 diamond finials over the 2 joins of the rafter and upright using 4 x 40mm screws per finial. Secure the second rafter in the back rebates of the uprights in the same way. 70mm
• We recommend that time is taken to read the instructions before starting assembly, then follow the easy step by step guide. The instruction sheet is only a guide to the assembly. Certain items may not be shown to scale. • Check all components prior to assembly • Drill all components where indicated. • This product should be assembled by no less than two people. • Never attempt to erect the assembly in high winds.
x2
2. Seat back to uprights Drill six holes in the seat back as shown in the diagram. Place the seat back on the seat between the two uprights. Secure through the drilled holes into the legs of the uprights using 4 x 70mm screws.
40mm
6. Roof slats Lay a slat section on 1 side of the roof with the 2 shorter slats at the apex. Spread the slats out evenly and secure using 2 x 40mm screws per slat, screw through the slat and into the rafters. Repeat for the other other side of the roof. Attach the apex finials on the front and back at the roof apex using 4 x 40mm screws per finial.
Drill
Recommended tools for assembly
• Cross head screw driver • Drill with 2mm diameter drill bit • Step ladder No. 1 2 3 4 5 6 7 8 No. 9 10 11
Components Seat Seat back Back lattice Uprights Roof Rafters Roof slat section Diamond finials Apex finials Fixing Kit Screws 70mm Screws 40mm L-brackets
Drill
Roof slat
8
40mm
Rafter
7
5
Spread slats evenly
3. Back lattice to uprights 6
Drill four holes in the back lattice as shown in the diagram. Sit the back lattice on the top of the seat back. Secure through the drilled holes into the legs of the uprights using 4 x 40mm screws.
3
Drill
Qty. 14 112 2
Top view 70mm
Qty. 1 1 1 2 4 2 4 2
40mm
2 4 Drill
1
40mm
40mm
IMPORTANT: RETAIN FOR FUTURE REFERENCE READ CAREFULLY Periodically check all fastenings for tightness For domestic use only We constantly improve the quality of our products, occasionally the components may differ from the components shown and are only correct at time of printing. We reserve the right to change the specification of our products without prior notice.
2010 © Rowlinson Garden Products Ltd