Digital%20fuel%20fitting%20instructions

Page 1

Fuel

Empty Full

Fuse 5A

= 5 Ohms = 90 Ohms

or Empty Full

= 3 Ohms = 180 Ohms

S_180 S_90

Ohms Range Switch

Installation 1.

Cut a Ă˜53mm diameter hole and fit gauge.

2. Connect the black wire to a good chassis ground. Ensure good ground connection between temperature sender unit. 3. Connect the red wire to a fuse accessory or the ignition switch circuit. 4. Connect the gauge Orange wire to the fuel sensor terminal. 5. Display Dimmer connect the purple wire to headlights or parkers 12V to cut the brightness by 50% . Note: If the purple wire is not connected to the headlights, then it should be earthed (battery neg). If the above gauges are used in Marine application or two terminals senders, connect as picture below:

Orange wire from Gauge

To Warning Light (negative side)

Orange wire from Gauge To battery negative

To battery negative

Empty Full

= 3 Ohms = 180 Ohms

Or Empty Full

FA 12 Dec 2012

= 5 Ohms = 90 Ohms


Fuse 5A

Empty Full

= 3 Ohms = 180 Ohms

Installation 1.

Cut a Ă˜53mm diameter hole and fit gauge.

2. Connect the black wire to a good chassis ground. Ensure good ground connection between temperature sender unit. 3. Connect the red wire to a fuse accessory or the ignition switch circuit. 4. Connect the gauge Orange wire to the fuel sensor terminal. 5. Display Dimmer connect the purple wire to headlights or parkers 12V to cut the brightness by 50% . Note: If the purple wire is not connected to the headlights, then it should be earthed (battery neg). If the above gauges are used in Marine application or two terminals senders, connect as picture below:

Orange wire from Gauge

To Warning Light (negative side)

Orange wire from Gauge To battery negative

To battery negative

Empty Full

FA 12 Dec 2012

= 3 Ohms = 180 Ohms


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.