Trouble Shooting

General Issues

ISSUE POSSIBLE CAUSE

Elevator won’t tilt • Hydraulic Hoses not plugged into tractor correctly • jammed Elevator • Bent Ram • Oil flow from tractor too low

Elevator won’t start • Hydraulic Hoses not plugged into tractor correctly • jammed Chains • Oil flow from tractor too low

Elevator works but Cross Floor won’t go in one or either direction • No power at electric controller • jammed Chains • Damaged wiring • Defective Coil on valve

Tail Gate opens unexpectedly

Cross floor won’t stop

Elevator stall

Feed Controller does not work

Joystick Controller does not work

Weighing system Not Working • Broken catch latch spring • Latch spring tension to lose

• Feed controller switch in (silage mode)

• Oil flow, pressure from tractor too low • Cross floor speed set to high • Pause button presses

• Not plugged into wagon • Damaged wiring • No power

• Not plugged into wagon • Damaged wiring • No power

• Battery flat • Out of range • Device not connected

SOLUTION

• Clean and plug into tractor correctly • Check for foreign objects in elevator body • Increase oil flow to 50-80 Litres • Replace Ram

• Clean and plug into tractor correctly • Check for foreign objects in elevator chains • Increase oil flow to 50-80 Litres

• Check power fuse, power at controller • Check for foreign objects in Cross

Floor chains • Check Controller plugged into machine • Check electrical cabling for damage • Replace Coil

• Replace the Latch spring • Tighten Latch spring tension

• Switch to bale mode

• Increase oil from tractor • Adjust feed control to slow cross floor • Release pause button

• Plug it in • Check wiring • Check power supply

• Plug it in • Check wiring • Check power supply

• Check battery voltage, should be 3.6V replace if voltage low. • •Move closer and try again • Check settings and re connect, also check • 31uetooth in turned on in device

Feed Control Issues (Silage Mode)

ISSUE POSSIBLE CAUSE SOLUTION

Too much material being feed • Elevator running too fast • Feed control setting too high • Decrease oil flow • Adjust Feed Control down - Black Knob clockwise

Not enough material being feed • Elevator running too slow • Feed Control setting too low • Increase oil flow • Adjust Feed Control up - Black Knob counterclockwise

Cross floor not moving •

Cross floor won’t stop • Feed Control setting too high • Adjust Feed control up

Black Knob clockwise

• Adjust Feed Control- Black Knob Clockwise

Pusher moving too fast • Rear bin speed too high

Pusher moving too slow • Rear bin speed too low

Pusher not moving • Rear bin speed too low • Pressure relief valve to low • Adjust Rear Floor speed down - Allen key clockwise

• Adjust Rear Floor speed up - Allen key clockwise

• Adjust Rear Floor speed up - Allen key clockwise • Increase pressure relief - Black valve allen key counter - clockwise ( 1/4 turn at a time) Check

Adjustments section of this document before adjusting