Adjustments

Bed Storage Floor Chains

It is important to keep this machine adjusted correctly to get the best performance out of this machine and to reduce wear and tear on components resulting in less down time and broken components. Follow the short instruction below to correctly adjust the bed floor storage chain assemblies.

• Check to see if the chains need to be adjusted • Tighten up Nut 1 whilst holding Nut 2 with a 24mm ring spanner until the floor slats are just sitting on the rear chain guides or contacting the chain guide 20 mm down on the front side (see drawing). Adjust Nut 1 at small intervals.

ADJUSTMENT

Elevator Chains

It is important to keep this machine adjusted correctly to get the best performance out of this machine and to reduce wear and tear on components resulting in less down time and broken components. Follow the short instruction below to correctly adjust the bed floor storage chain assemblies. • Check to see if the chains need to be adjusted • Loosen off the bolts that clamp the elevator shaft cover to the elevator screen • Loosen off the 4 x M12 locking bolts on the Drive Shaft Idler

Bearing • Loosen off Adjuster Lock Nuts 1 & 3 • Adjust the chain tension adjuster Nuts 2 & 4 until the chain/slat is at the desired tension of 75mm total travel. Check that the drive shaft is close to parallel. • Tighten up Adjuster Lock Nuts 1 & 3. Tighten up the 4 x M12 locking bolts on the Drive Shaft Idler Bearing • Recheck elevator tension is still correct • Re-clamp elevator shaft cover so there is a minimum 5mm gap between the elevator slat and the elevator shaft cover.

Refer to drawings on next page for part locations DO NOT OVER TENSION THE ELEVATOR & FLOOR CHAINS. DAMAGE & EXTENSIVE WEAR WILL OCCUR

ADJUSTMENT

ADJUSTMENT OF THE X-FLOOR CHAINS

It is important to keep this machine adjusted correctly to get the best performance out of this machine and to reduce wear and tear on components resulting in less down time and broken components. Follow the short instruction below to correctly adjust the bed floor storage chain assemblies.

• Check to see if the chains need to be adjusted. • Loosen off the large Nut 1 locking nut. • Tighten up the large Nut 2 until the X-Floor slats are just sitting on the lower panel returns (see drawing). Adjust Nut 2 at small intervals and adjust both nuts at the same time to get an even chain tension on both sides. • Tighten up large Nut 1 to lock up the shaft idler shaft assembly. • Recheck chain tension is still correct.

Slat Just Touching

Nut 2 Nut 1

LOADED MACHINE BALE LAYOUT