Warnings

• ALL persons and animals must be keep WELL CLEAR of the machine in operation and when traveling • Shut off the tractor BEFORE trying to clear feed material or cut strings/ net from anywhere around the machine. • BEFORE attempting maintenance or any work, ensure the tractor engine is shut off, the handbrake is applied and no one is near the hydraulic controls. • DO NOT allow any person(s) to ride on the machine at any time. • EXTREME CARE must be taken when traveling on uneven ground or hill country. A steep or slippery slope may cause the feeder or tractor to rollover. This could cause INJURY or DEATH. • EXTREME CARE must be taken when traveling on hill country with a bale in the cradle, so it doesn’t roll out Optional side bars can be purchased from

Hustler. • ENSURE the jack stand is PROPERLY latched in place before driving the tractor away. • This machine is designed for off-road use ONLY. If towing on the road, two safety chains rated to at least 3.2 metric tons each MUST be used and securely fastened in the correct cross over technique. Tail lights and a registration plate may be required. It is the owner’s responsibility to adhere to the law in their country/state. • Take CARE when travelling with a bale up on the rear forks as this lessens the stability of the machine. The closer the bale to the ground to lower the centre of gravity. • ALWAYS ensure the rear loading forks are pointing up approximately 45 when travelling without a bale • NO alteration or modification is to be done on this machine unless undertaken by Hustler or its authorized dealer. This will void the warranty • Vehicle must be operated no more than 30km/h when the bale feeder is attached. • KEEP CLEAR of moving feed chains and bars DO NOT use for transporting anything other than a bale. • KEEP CLEAR of feed bars. These have sharp points which are needed for teasing the bale • ENSURE axles are adjusted to the correct width setting for the terrain.

Wide for hilly terrain • ENSURE the jack pin is securely in place so the jack doesn’t move in either the stand or transport position.