Adjustments

EASY CLEAN WIPER

• Recommended to be cleaned before use, daily or any time of buildup. • Turn off tractor/telehandler. • Release both silver end latches of the wiper, let wiper panel slide open. • Remove excess material. • Close wiper by pulling bottom of wiper with one hand and pushing the top of wiper panel with other hand. (Keep fingers clear of pinch points). • Press both latches down into lock position.

ADJUSTING WIPER PANEL

• Wiper Panel must be set up as close to the top drum as possible. (this reduces any build-up in the wiper with sticky bales) • Remove front and rear plastic covers. • Loosen M16 bolts at both ends. • Slide wiper towards the top drum, to reduce the gap to a minimum. (keep fingers away from pinch points) • Retighten M16 bolts at both ends, (recommended torque 140Nm). • Latch must be down (locked) when resetting wiper position.

ADJUSTMENT CONT.

ADJUSTING PLATFORM - X2500 Only

• The platform can be adjusted to suit the type of bale you’re feeding. • Factory setting as shown below. This is great for round bales and most square bales. (Please note these pictures are shown without the plastic platform for better understanding for the reader, it is not necessary to remove the plastic when altering the platform position).

Remove this bolt

• However, if you have trouble feeding tight square bales this simple adjustment can help. • First remove the steel platform flap bolted to the bottom edge of the plastic cover. Replace the bolts and washers once flap is removed. • Extend the platform ram about 100mm. • Remove the two fixed bolts which are not in the slots and loosen the other six bolts. • Using a bar for leverage, (or a hoist) slide the base of the platform up. • Refit the bolts and tighten.