International Journal for Research in Applied Science & Engineering Technology (IJRASET)

ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.538

Volume 11 Issue IV Apr 2023- Available at www.ijraset.com

This cut-off frequency allows the waveguide to work as a high pass filter and removes the lower frequency. For optimum horn design, we take RE = RH = RO=70.19 cm

The position and length of the probe is calculated through empirical relations and a very small change in these parameters can affect the reception of signal greatly as shown in Figure 2.

IV.FABRICATION

Effective planning was done beforestarting the fabrication to minimize the time required and utilize the resources - man, machine, material and money optimally.

Fabricated Horn is shown in Figure 3 and Final Assembly is shown in Figure 4.

V. RESULTSANDDISCUSSIONS

The design basis mentioned earlier are simulated after specifying material properties, geometrical specifications, boundary conditions, etc. of the horn designed.

Material used: Aluminium