OPERATING INSTRUCTIONS

Note: The Model - 527 Bolster Extension can be stowed in the 90° left or right position.

CAUTION: WHEN DIES ARE LOADED AND UNLOADED, THE BOLSTER EXTENSION MUST BE SECURELY LOCKED.

1. Pull the Locking Mechanism Lever located under the bolster extension forward to the unlock position and move Bolster Extension from the 90° left or right position.

2. Release Locking Mechanism Lever after the Bolster Extension is moved about 30°. The lock will then engage automatically when the next lock position is reached.

Note: The Locking Mechanism is spring loaded to lock when the groove in the hinge lines up with the locking mechanism. If the spring breaks replace it immediately.

3. Inspect Bolster Extension to ensure that it is properly positioned and securely locked.

4. Place die carefully onto the Bolster Extensions inside the spring loaded die stops.

CAUTION: DO NOT EXCEED RATED LOAD LIMIT.

5. Roll die onto bolster.

To stow Bolster Extension in the 90° left or right position pull Locking Mechanism Lever to the forward unlock position and swing Bolster Extension to the left or right.

CAUTION: MAKE SURE DIE IS WIDE ENOUGH (L-R DIMENSION) TO BE ROLLED SAFELY ON THE BOLSTER EXTENSIONS.