CleanCube classic
«A New Paradigm for Decontamination Efficacy»
CLEANCube
classic - the versatile all-rounder!
Top performance, easy to use, convenient.
Designed, engineered and manufactured in Switzerland, CleanCube classic is an indoor nebulization device made out of robust aluminium and galvanised premium steel having the highest level of corrosion resistance. An extremely powerful and constant air-stream, generated by a combination of advanced high rev turbine blower technology, a most precise peristaltic pump dosing exactly the desired disinfectant output and a specially staggered vortex nozzle for swirling the jet-stream, atomizes the hydrogen peroxide disinfectant into tiniest particles of only approx. 3 microns.
3-D Disinfection
Top Performance and Versatility
The ultrafine droplets are distributed everywhere within a room (3-D) thanks to a constant airflow agitating the air. This leads to an extremely high disinfection density in the air reaching all surfaces, i.e. none will be left out, not even the ones which are most difficult to access, including gaps, cracks and corners. As the particles of the nebulized fine mist are extremely tiny, they increase substantially the surface contact, attacking bacteria membranes exponentially.
Top performance despite compact dimensions of 37x37x40cm and a weight of only 14.2kg. A large liquid tank of 3 lit. connected to a precise dosing pump ensures an even flow rate and enables precise dosing, irrespective of the fill level of the tank (many devices on the market have a higher output the fuller the tank). Depending on selected disinfectant dosage per m3, approx. 500m3 can be treated with one single filling (dosage: 6ml/m3).
This 3D-method proves to be successful to fight against resistant micro-organisms such as MRSA and nosocomial infections, thus achieving a reliable, flawless, time and cost-saving air and surface decontamination. The internationally renowned Swissatest Institute ascertained in a recent study that 99.9999% of the s.aureus and e.coli bacteria were eliminated when using CleanCube devices in combination with CleanLine disinfection liquid.
The spray gun with nozzle can be rotated by 360°, thus allowing to always point in the right direction. The gun can also be removed or optionally be extended by a tube of over 2 meters, thus allowing to treat pipes or ventilation systems. A remote control allows to ON/ OFF the CleanCube classic without entering the room, a feature which is particularly useful when changes of planning occur and disinfection process can be interrupted from the outside of the room. This all-rounder will satisfy virtually everyone as it is suitable for small and larger rooms alike, can even be connected in series, e.g. 4 devices will be able to decontaminate a hall of up to 2’000m3, or can be used for air conducts’ treatment. It is an ideal device for hospitals, clinics, wellness & fitness centres, companies’ premises, hotel rooms, restaurants & canteens, animal farms and -transport, food processing industry, train carriages, planes and ships.
*The test was carried out according to the protocol of the ATS Labs which bases on different AOAC methods like AOAC 960.09, 961.02, and different Guidelines from the US EPA (DIS/TSS 2; DIS/TSS-2; DIS/TSS-9; etc.)
2
CleanService Group AG | Wilerstrasse 2180 | 9230 Flawil | Switzerland | www.cleanservicegroup.ag Tel. +41 71 555 11 30 | Fax +41 71 394 14 83
Ease of Use The CleanCube classic calculates automatically the time of disinfection required based on the room size and the desired disinfection liquid concentration inputted through the use of its LED & Key Control. It checks automatically the liquid level inside the tank and informs whether the process can begin. After starting the device, it will give visual and acoustic signals for 15 seconds. The room has to be left during this time-lap, then the device runs. The reach of the jet-stream is 12-20 m and room volumes of up to 500-600 m3 are treated. This nebulization process will normally take just a few minutes for a standard room. After the inputted time has elapsed, the CleanCube classic switches off automatically and informs the end of its running time through an acoustic signal. The disinfection process however is not yet finished: a short waiting time (length according to table in Operation Manual) is needed to allow for all particles in the air to settle down and to impact on the micro-organisms inside the room. Thereafter the latter can be safely entered again, no rinsing or post-cleaning is needed. Further to the above described “manual” settings, an automatic program is available where at set days and times the CleanCube classic will automatically run for a chosen period. This allows decontamination e.g. on week-ends or in the middle of the night, when nobody is around. The third program called “STEP” is particularly efficient: It enables up to 3 running time and 3 waiting time inputs, allowing after each running time the ultrafine liquid particles to settle down and to eliminate the micro-organisms.
CleanService Group AG | Wilerstrasse 2180 | 9230 Flawil | Switzerland | www.cleanservicegroup.ag Tel. +41 71 555 11 30 | Fax +41 71 394 14 83
3
Accessories Handy accessories are available to enhance the convenience when handling the CleanCube classic, a complete list can be downloaded on cleanservicegroup.ag. A handy trolley enables the CleanCube classic to be rolled from room to room as well as to place the device at the most suitable place in the room for running the disinfection process from an elevated position. It also offers storage space for the disinfection liquid, further accessories and protective equipment.
The case for the CleanCube classic is ideal for its secure and dust-free storage as well as for its accessories. Transporting the device becomes even easier as the cube, together with its accessories, can be rolled just by pulling out the extendable handle of the case. Further, device and accessories are well protected against external shocks during transports.
The Tube & Gun accessory is a special, 2 meters long extension tube for the provision of air and disinfectant to the spray-gun, thus allowing the disinfection of pipes or ventilation systems.
Technical Data
4
Power requirements:
220 - 240 V, 50Hz
Amperage:
max. 6.3 A
Operating temperature:
5°C to 40°C
Engine Power:
1′200 W
Engine rotation speed:
19000 rpm
Tank capacity:
3 liter
Casing dimensions:
370 x 370 x 400 mm [14.57 x 14.57 x 15.75 inch]
Weight (empty):
14.2 kg
Output per hour:
1 lit
Output per min:
16.6 ml
Reach:
12-20 m
Disinfection per 10 min:
28 m3 (with concentration of 6ml/m3)
CleanService Group AG | Wilerstrasse 2180 | 9230 Flawil | Switzerland | www.cleanservicegroup.ag Tel. +41 71 555 11 30 | Fax +41 71 394 14 83
05/2016
610.74 KWp 3980 m2
CleanService Group AG
is a Company of Hofast AG, CH-9230 Flawil, Switzerland