smart driver™ power supply There are a variety of models to choose from, depending on desired usage. Each model has slightly different features based on popular customer requests. We will recommend the ideal power supply depending on which key feature is most important. A factory representative should advise which model to use if the lamp area is on the lower or upper end of the range. AC INPUT - ANALOG SERIES Smart Driver power supplies are specifically engineered to illuminate Light Tape®. Whether it is one piece or ten, it is possible to do it all with one Smart Driver™. Our AC input power supplies adjust voltage and frequency to illuminate Light Tape® in the most efficient way. All you need to know is the total surface area of the Light Tape® you wish to illuminate to determine the proper sized Smart Driver™.
FEATURES: • Quiet • Worldwide voltage capacity • Compact Design • Blink and Dimmer Switch • Visual LED System status indicator • Lightweight • Short circuit an overload protection • CE, UL, and CSA compliant
MODEL
E2
LIGHT TAPE RANGE
OUTPUT WATTS PER SQUARE INCH
MILLIAMPS PER SQUARE INCH
HIGH
0.028 in2 (0.0043 cm2)
0.342 in2 (0.0530 cm2)
MEDIUM
0.016 in2 (0.0025 cm2)
0.191 in2 (0.0296 cm2)
LOW
0.011 in2 (0.0017 cm2)
0.133 in2 (0.0206 cm2)
ENERGY CONSUMPTION
INPUT VOLTAGE
OUTPUT VOLTAGE
OUTPUT FREQUENCY
200 - 300 VAC
500 - 1000 Hz
SD400
200 - 400 in2 1300 - 2500 cm2
76.4 mA 6.4 W
120 - 240
SD1000
400 - 1000 in2 2500 - 6500 cm2
191 mA 16 W
120 - 240
201 - 300 VAC
501 - 1000 Hz
SD2000
1000 - 2000 in2 6500 - 13000 cm2
382 mA 32 W
120 - 240
202 - 300 VAC
502 - 1000 Hz
SD4000
2000 - 4000 in2 13000 - 25000 cm2
764 mA 64 W
120 - 240
203 - 300 VAC
503 - 1000 Hz
SD8000
4000 - 8000 in2 25000 - 52000 cm2
1528 mA 128 W
120 - 240
204 - 300 VAC
504 - 1000 Hz
*MEDIUM OUTPUT AT FULL LOAD
Copyright 2015 Light Tape® Electro-LuminX Lighting Corporation
ac smart driver™ measurements
SD-50
SD-150
DSD-200
Length: 4 1/4 inches (107.95mm)
Length: 4 1/4 inches (107.95mm)
Length: 4 7/16 inches (112.71mm)
Width: 3 5/8 inches (92.075mm)
Width: 3 5/8 inches (92.075mm)
Width: 2 3/4 inches (69.850mm)
Height: 1 15/16 inches (49.212mm)
Height: 1 7/8 inches (47.625mm)
Height: 1 5/8 inches (41.275mm)
Weight: 0.90 lbs
Weight: 0.90 lbs
SD-400
SD-1000
SD-2000
Length: 7 9/16 inches (192.09mm)
Length: 6 4/8 inches (165.10mm)
Length: 7 inches (177.80mm)
Width: 3 1/2 inches (88.900mm)
Width: 4 11/16 inches (119.06mm)
Width: 4 3/4 inches (120.65mm)
Height: 1 15/16 inches (49.212mm)
Height: 2 5/16 inches (58.737mm)
Height: 2 3/8 inches (60.325mm)
Weight: 2.0 lbs
Weight: 2.60 lbs
Weight: 2.70 lbs
SD-4000
DSD-4000
DSD-8000
Length: 9 7/8 inches (250.82mm)
Length: 11 3/8 inches (288.92mm)
Length: 9 7/8 inches (250.82mm)
Width: 4 3/4 inches (120.65mm)
Width: 7 1/4 inches (184.15mm)
Width: 4 3/4 inches (120.65mm)
Height: 2 1/4 inches (57.150mm)
Height: 2 3/4 inches (69.850mm)
Height: 2 1/4 inches (57.150mm)
Weight: 4.20 lbs
Copyright 2015 Light TapeÂŽ Electro-LuminX Lighting Corporation
Weight: 4.15 lbs
E3
smart driver™ power supply SAFETY AND HANDLING It is important that you operate Light Tape® and Smart Driver Power Supplies within their parameters. Over current will destroy electrical connections. • • • •
250 volts is mid range and recommended set point! The external dimmer switch on Smart Driver™ controls the output voltage and frequency. Use a voltage meter to determine volts / hertz from Smart Driver™ to Light Tape®. Always set power supply output voltage per factory recommended setting Low : 200 volts l Medium : 250 volts l High : 300 volts • We DO NOT recommend exceeding 300 volts. Contact us if the Smart Driver™ is operating outside of range. • Red LED indicates the following : 1. Short Circuit Protection : Check wiring if light is on. 2. Overload Protection: Verify that lamp area is acceptable, or for possible damage to lamp. • Always treat Light Tape® and Smart Driver™ with care and respect as one would with any device where electrical current is present. • Please follow local electrical codes
E4
Copyright 2015 Light Tape® Electro-LuminX Lighting Corporation