Causes that the air conditioning does not cool

Causes That the Air Conditioning Does Not Cool When an air conditioner does not cool, it can be due to multiple reasons, not just because of the lack of gas. Most people think of this as the first choice of not cooling their equipment, but it is not the only one.

Of course, this is one of the causes that produce the Air conditioning in Tomball TX not to work properly, but a great part of the time is due to other factors, since, if the installation was done well in its day, it should not Lose the gas unless it has been Produced a leak for any reason, and then you need a specialist in Kingwood TX local air conditioning repair.

Below, we will list different types of breakdowns or problems that make an equipment of Air Conditioning in Tomball TX does not cool: -Lack of gas. As almost everyone knows, this is a cause of an air conditioner not working. The specialists in Tomball TX AC repair know that the lack of gas may be due to a leak in the refrigeration circuit either because it is poorly installed or because some small hole has been opened in a pipe or weld.

-Starter capacitor. When one of the starter capacitors does not work, either the fan or the compressor, we will see that the indoor unit works properly but does not get cold. When the fan starter capacitor is broken, it does not rotate. If we go to the outdoor unit and the fan does not work, the most likely is that the capacitor is damaged. Instead, when the compressor condenser does not operate we will see the outdoor fan operate properly, but the compressor will be stopped so that the indoor unit will work properly but will not freeze cold. When the fan itself makes more noise than the compressor the way to find out if the compressor is working or not is touching the pipes. If the pipes are at room temperature it means that it is not working.

-Dirty Filters. When the filters are dirty there is, a pressure drop of the gas in the indoor unit because the air does not circulate as it should, therefore we can notice that the equipment cools more (even freezes) but does not air-condition or cool our room. It will also affect the electrical consumption of our equipment upwards (consuming more energy), and even in high power equipment, it can come to a standstill because of the pressure switch jumps, which is neither more nor less than a safety system for when the pressure is too low or too high. To clean the filters, you can do it simply with your hands and a little soap, but you can also use a soft-cell brush and hot water, this will make them cleaner and disinfected.

-Dirty Fan. If the previous step is not done, ie the filters are not cleaned, small particles of dust and dirt will accumulate on the inner fan. This dirt will clog the fan's slits) causing the airflow is not correct and therefore adversely affecting the operation of our air conditioning. Another drawback, when the fan is dirty, is that odors occur when the equipment is turned on.