LOUISVILLE LADDER PLANKS AND STAGE READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING WORK. IF YOU DON´T UNDERSTAND OR NEED MORE INFORMATION CALL 1-(800)-666-2811 FOR ASSISTANCE.
INSTALLATION INSTRUCTION SHEET FOR ENDRAIL / END TOEBOARD SYSTEMS MER-01 / MER-02 WARNING 1. Failure to comply with all instructions result in serious injury. 2. Make sure this kit fits your stage. Refer to Step 1 of these instructions. If you have any questions concerning the use of this kit on other Louisville Ladder Inc. products, call 1-(800)-666-2811 for assistance. 3. Before installing this kit, identify all kit components. If any components are missing or damaged, return the kit to place of purchase. Do not substitute any components. 4. Inspect the stage before installing this kit. Repair or replace any damaged or missing stage parts before using the stage. Use only Louisville Ladder Inc. replacement parts. If unable to repair, discard the stage. APPLICATION CHART
Stage Length
Three Sided System Guardrail 9 Ft. 13 Ft. 9 Ft. 13 Ft. Post Guardrail Guardrail Toeboard Toeboard Assembly Length Length Length Length
Web Brace Assembly **
Endrail Assembly
MER-01* MPT-01 MGR-09 MGR-13 MTB-09 MTB-13 MRF-01 MER-02* 5 4 2 0 1 0 2 2 6 4 2 0 1 0 2 2 8 4 2 0 1 0 2 2 10 4 0 2 0 1 2 2 12 5 0 2 0 1 3 2 14 5 0 2 0 1 3 2 16 5 4 0 2 0 3 2 18 5 0 4 0 2 3 2 20 6 6 0 3 0 4 2 24 6 6 0 3 0 4 2 28 7 4 2 2 1 0 2 30 7 8 0 4 0 0 2 32 7 4 4 2 2 0 2 36 8 10 0 5 0 0 2 40 8 6 4 3 2 0 2 * MER-01 required on 12" and 14" wide planks, MER-02 required on 20", 24" and 28" wide ** Required on planks with side rails LESS than 6" tall
Stage Length
Four Sided System Guardrail 9 Ft. 13 Ft. 9 Ft. 13 Ft. Web Post Guardrail Guardrail Toeboard Toeboard Brace Assembly Length Length Length Length Assembly **
Endrail Assembly
MER-01* MPT-01 MGR-09 MGR-13 MTB-09 MTB-13 MRF-01 MER-02* 5 4 4 0 2 0 2 2 6 4 4 0 2 0 2 2 8 4 4 0 2 0 2 2 10 4 0 4 0 2 2 2 12 6 0 4 0 2 3 2 14 6 0 4 0 2 3 2 16 6 8 0 4 0 3 2 18 6 0 8 0 4 3 2 20 8 12 0 6 0 4 2 24 8 12 0 6 0 4 2 28 10 8 4 4 2 0 2 30 10 16 0 8 0 0 2 32 10 8 8 4 4 0 2 36 12 20 0 10 0 0 2 40 12 12 8 6 4 0 2 * MER-01 required on 12" and 14" wide planks, MER-02 required on 20", 24" and 28" wide ** Required on planks with side rails LESS than 6" tall
TOOLS NEEDED FOR ASSEMBLY: NO TOOLS NEEDED
www.louisvilleladder.com Address: 7765 National Turnpike, Unit 190 Louisville, KY 40214 Phone: 1-(800)-666-2811
Rev 1. 2011
LOUISVILLE LADDER PLANKS AND STAGE
INSTRUCTIONS: STEP 1 Check that you have the proper endrail kit model for your width of stage. Kit model MER-01 fits 12” and 14” wide stages. Kit model MER-02 fits 20”, 24”and 28” wide stages. STEP 2 Attach (1) J-bracket ① to each end toeboard ② piece as shown in Figure 1 using (1) ¼ “-20 X ¾” long hex bolt ③ and (1) ¼ “-20 wing nut ④. Do not tighten wing nut at this time.
STEP 5 Hold endrails ⑦ between the two end guardrail posts to locate which U-bolt holes to use for mounting and insert the (2) 5/16” U-bolts around the guardrail posts and through the holes in the endrail and fasten with the (4) 5/16”-18 wing nuts as shown in Figure 2. STEP 6 RECHECK FASTENERS TO ENSURE ALL ARE TIGHT BEFORE USING.
STEP 3 Attach end toeboard and J-bracket assemblies to the guardrail posts ⑤ by loosening the wing nuts ④ on the U-bolt ⑥ holding the side toeboard. Then hook the J-bracket ① around the U-bolt as shown in Figure 2 and the retighten the wing nuts of the U-bolt. Repeat step with other end toeboard assembly to opposite guardrail post.
Figure 1 Figure 2 STEP 4 Nest the 2 end toeboards together and slide them outward against the side toeboards. Fasten the end toeboards ② together where the slots line up with (1) ¼ “-20 X ¾” long hex bolt ③ and (1) ¼ “-20 wing nut ④ and tighten. Finish tighten the wing nut holding the J-brackets on.
www.louisvilleladder.com Address: 7765 National Turnpike, Unit 190 Louisville, KY 40214 Phone: 1-(800)-666-2811
Rev 1. 2011