HIGH QUALITY OF COPPER WIRE MANUFACTURES IN PUNE


Copper wiring is the most versatile plumbing material that can be concealed for both hot and cold water applications. These tubing’s are available in different forms including coiled rolls and straight pipes in varying diameters. Copper wires are known for their high resistance against corrosion. Although the probability for damages are less, but you should always be ready for the repair. Easiest way to repair copper wiring is replaces the damaged section of the pipe. Basically copper wires are joined in three ways: solder joints, compression fittings and flared tubing. For most of the fittings, you can mix and match the type of connection to leak proof line. A rigid wiring with a soldered joints are perfect for under the sink application, flared or compression fittings are perfect for flexible wiring used to carry water to the faucet.
Identify the size of the pipe you need before going to the hardware store. You can figure out the size accurately by cutting a small section of pipe. You can carry this as sample, or may also measure the size of the pipe using tape or making marks on the thread. Don't forget to measure the length of the pipe; you would need as a replacement. The first step is to remove the pipe you need to replace. Cut the section slowly, or you may dent the wire by applying greater force. Measure the length of the pipe that has been removed. Rub wool or steel at the end of the pipe to make the surface smooth. The smooth surface will provide better grip for the compression fitting. Calculate the size of the replacement pipe. Remember, the size of the replacement pipe will not be same as the patch that has been created. Also consider the length of the union fitting. The fitting has a stop point at the bracket that takes up the part of the pipe.
Firmly attach the fitting nuts and compression ring onto the existing pipes, and then place the pipe on the existing patch. You will have to gently flex the pipe for making the adjustment. Slide compression ring and secure the fitting with the support of the thumb. By using two wrenches, tighten the compression nuts. Use one wrench to hold the nut and other for sliding. After the job is done, slowly turn back for water to check the leaks. Turn of the water, if you need to tighten the joint once again. Maitree Industries Pvt. Ltd. is one of the leading Copper wire manufactures in Pune supplies copper products like copper strip, copper bar, trolley wire, and copper rod varieties and many more. To know more about the copper products visit http://miipl.net/ OR call 02041230308