Copyright © MP Lighting All technical information in this document is subject to change.
dual circuit rail electronic surface mount TRANSFORMER
TLW120E150-DC7C (Old Code: 2C12150E)
TLW120E230-DC7C (Old Code: 2C12230E)
Spec Sheet
Material:
Steel case and copper tube with electroplated finish.
Mounting:
Surface mounts to standard J-box.
Electrical:
100% Duty cycle. Auto reset circuit protection. Can only be used on MP dual circuit rail system. Stem can be used as a rail support. Can be dimmed using electronic low voltage dimmers (i.e. Lutron Diva).
Ø6-3/8” Ø162mm 2-3/8” 60mm
AC Input Voltage: DC Output Voltage: Output Wattage:
7” 178mm
Maximum Load: Power Factor: Typical Efficiency: Short Circuit Protection: Overload Protection: Operating Temperature: Maximum Case Temperature: Humidity (Non-Condensing): Weight:
* Custom length available.
-
Offset
DC
Canopy
C
Wattage
Canopy
150 = 150W 230 = 230W
C = circular
Offset
Finish
7 = 7” / 178mm from ceiling to bottom of rail
MC = matte chrome BN = brushed nickel
X = custom length
t 604.708.1184 f 604.708.1185 mplighting.com
Approval:
Finish
Dry locations. Approved to UL standards by CSA/US.
-
www.mplighting.com
TLW120E
Mount
f 604.708.1185
Wattage
t 604.708.1184
Code
120V, 60Hz 12V 150W Max. (TLW120E150-DC7C) 230W Max. (TLW120E230-DC7C) Depends on wattage of fixture 95% Min. 80% Yes Yes -10 ~ 50°C (14 ~ 122°F) 65°C (149°F) 5% ~ 95% 3 lb / 1.4 kg
[Project]
[Quantity] [Note] [Type]
Single Circuit
Dual Circuit Datecode 0809