Cleared on the Left,
Starting the Left By Ltjg. Robert Stochel
was in the left seat of Liberty 604, preparing for the first launch of the day for a surface-surveillance-and-control (SSC) mission. The flight schedule was light, and we walked early enough to avoid rushing our 1445 departure. Our plane was placed in the “six pack,” the area located a few yards behind jet-blast deflector (JBD) No. 2. The electrical-power station was under the port engine, and the cords were routed under the fuselage. The pneumatic-air cart was about seven feet in front of the port engine and, like the cords, was routed under the fuselage to the starboard engine for a “standard” engine start. Normally during field operations, the electricalpower cart and huffer are placed on the aircraft’s right side, which was the only configuration I had been exposed to so far. This shipboard configuration appeared nonstandard to me for two reasons: I never had started with the cords and pneumatic-air hose routed under the aircraft, and it was my first start on the carrier from this particular spot. One ground lock still needed to be installed on the main-landing gear as a precaution, so we had to make sure that was removed before we taxied. After completing the prestart checks with the carrier-aircraft plane commander (CAPC), I asked him and the command combat-information-center officer (CICO) if everyone was ready to start the right engine. The mantra usually is, “Check me chocked, plugged, manned, and clear.” After that sequence, both pilots concur that the 12
left and the right sides are clear for start. The plane captain will signal he is ready, and the pilot will start the engine. The start of the right engine went exactly as briefed, and I was ready to start the left motor. After running through the checks, I briefed the second engine start. I saw the huffer still was inside the “safety chain” but figured that position was part of the normal shipboard procedure—my first mistake. I asked the CAPC and CICO if they were ready to start the left engine, and they agreed. I thought—my second mistake— the plane captain, who was under instruction, made a signal to start. He raised his hands in the direction for a start but really did not give the start hand signal. I then placed the condition lever into run and toggled the engine-start switch. Two seconds after rotation, we were signaled to secure the engine. We did so without lighting off the engine. I asked the CAPC what happened, then saw the huffer with the driver in the cart, and realized the cart was not supposed to be inside the safety chain. The CAPC explained to me exactly what to do for these starts (which we should have discussed during the brief). No one was injured, and we carefully again went through the checklist to start the left engine. I was shaken by the event that just had happened, and it already had started to affect my performance. For the first time in my life, I had made an egregious mistake that could have killed someone. Meanwhile, I had forgotten about the ground lock that still was installed on the main-landing gear and almost had the Approach
