01 TURNING RISE ON/OFF

03 CHARGING THE INTERNAL BATTERY 04 CHECKING THE BATTERY LEVEL

Before using the internal battery or the Range Extender for the first time, completely charge the batteries. Charge the internal battery and/or the Range Extender as soon as you receive it. If you are not going to use the bike or the Range Extender, make sure the batteries are charged to at least 50% of their capacity every 3 months.

1. Plug the RS Smart Charger to the mains outlet. With the charger not being connected to the bicycle, the LED on the charger´s body will blink in blue.

2. Open the bicycle charging port cover and connect the charger aligning the connector correctly. The arrow on the charger connector must be aligned with the top part of the charging port.

The charger´s body LED will turn blue for 2 seconds and then it will start fading in and out cyclically until the battery is completely charged.

3. When the battery is fully charged, the charger´s body

LED will light in blue permanently.

4. Disconnect the charger from the bicycle´s charging port carefully pulling from the charger´s connector. Make sure the charging port´s cover is correctly closed.

While the charger is connected to Rise, the bicycle cannot be powered on. Disconnect the charger from the bike and turn the bike on to check the current battery level if you could not charge the battery completely.

If the charger´s LED lights in red when connecting the charger to the outlet or during the charging process, there is a charging anomaly. Immediately disconnect the charger and read the charger troubleshooting method in the Rise H Bluepaper technical manual. If the problem persists, contact an authorized dealer.

ERROR!

1

2

3

4

100%

RISE · HYDRO 2022 ORBEA | 7 EN

WITH SHIMANO DISPLAYS

Turn the bicycle on. On assemblies with the Shimano displays, the battery(ies) charge level will be shown on the screen.

WITH SHIMANO EW-EN100 JUNTION

Turn the bicycle on. The Shimano EW-EN100 junction will show in the LED1 the remaining battery charge of the battery(ies). The LED1 will display a green light until the battery charge is below 21%, after which the LED1 will show a red light. When the battery is almost depleted, the LED1 will blink in red.

100% - 81%

80% - 61%

60% - 41%

40% - 21%

20% - 1%

0%

LED 1

100% - 21%

20% or less

Almost depleted

COMPATIBLE GARMIN UNITS. ORBEA RS TOOLBOX

Turn you compatible Garmin unit (having previously downloaded and installed Orbea RS Toolbox on it) and navigate to the RS Toolbox field.

Then turn the bicycle on to see the current battery level.

If the battery level is not displayed on Toolbox, switch the bicycle off and on again to reset the connection.

Read how to download and install the Orbea RS Toolbox data field on your compatible Garmin unit in the dedicated section of this manual.