SIESTA CARE AND MAINTENANCE Notice the warnings and follow at all times the instructions of use of the product. To clean the plastic chairs and tables, use water and colourless and non-abrasive liquid detergents. Leave the soapy solution for a few minutes and then, if necessary, scrub the surface with a flexible bristle brush. Subsequently rinse with water. Avoid prolonged contact with coloured or fatty substances, because they can be absorbed by the polymer and leave stains. Thus, avoid prolonged contact with detergents or acidic or basic solvents. Abrasive cleaners that may affect the product must not be used, such as abrasives, glass cleaner, mops, etc. Do not use high pressure water cleaners because they can affect the polymer. In case of metal products with scratches or small spots of rust due to a lack of care in the maintenance, they can be slightly repaired by polishing the affected areas. Then, apply antioxidant priming, and finally, bright enamel paint. Do not expose the products continuously and for a long period of time outdoors. These products are suitable for an intense but not permanent outdoor use. To maximize the useful life of the product store it in a place protected from sunlight, humidity, saline environments, dirt and high temperatures when not in use. It is recommended not to block or cover the products. The use of products such as synthetic fibres, wood, aluminium, stainless steels, etc., is expressly not recommended by the manufacturer for use and/or exposure in areas with a significant level of salinity in the environment. The maintenance required by the synthetic fibre and textilene is of at least two annual cleanings to remove dust and environmental waste that can remain in the mesh or braiding, as deposited dust and pollution may be perishable. Thus, avoid prolonged contact with coloured or fatty substances (such as sun creams), since they can be absorbed by the material and leave permanent stains. To clean them it is recommended to use water with liquid, colourless and non-abrasive detergents. Leave the mixture of water with detergent acting a few minutes, and then, if necessary, scrub the surface with very flexible bristle brushes. Then rinse thoroughly. If you use water pressure systems for cleaning, be aware not to damage the surface. It is advised to clean and dry synthetic fibre properly before storing it for the winter, and do the same process at the beginning of the season, when will be used regularly.
OutDesign Group 100 East Linton Blvd., Suite 403A, Delray Beach, FL 33483 561.922.6160