http://questtecsolutions.com/
Using a PSI Pressure Gauge to Determine Water Tank Levels
Most tank level indicators utilized in industry contain either level gauge pressure or differential pressure calculating instrumentation. The variable either in situation is hydrostatic pressure, a stride from the specific weight of the water column because of gravitational pressure. Oddly enough, the demands exerted at the end of the 30-feet-high, Âź-inch-diameter water tube or perhaps a 30-feet-deep lake is the same, at 13 PSI (pounds per sq. inch). This characteristic causes it to be easy to measure and indicate nonpressurized water tank levels with simple pressure indicators. Instructions 1.
Define the size of the application. On non-pressurized tanks, every 27.71 inches water height will impose 1 PSI around the pressure gauge. A pressure gauge that reads zero to 10 PSI thus remains able
to showing as much as 277.1 inches of level, or about 23 ft. In most cases, discover the cheapest reading through PSI gauge you are able to that also fits your range, because attempting to read single-feet level on the zero to 50 PSI gauge could be past the gauge's capacity to even move its needle. 2.
Choose an available PSI pressure gauge range. Divide your greatest level by 27.71. In case your greatest level is 6 ft, divide 72 inches by 27.71 and discover an available gauge that's nearest to two.6 PSI. A zero to five PSI gauge works much better than a zero to 10 PSI gauge due to its greater mechanical resolution.
3.
Organize your materials. You'll need pressure gauge, tubing, connection fixtures to hook up with the foot of water tank, the letter for that tubing and a minimum of two shut-off valves. Use plastic if whatsoever feasible for the tubing and fixtures and snap-in fixtures also get this to project much simpler.
4.
Install your level system. Choose one valve as near to the tank as you possibly can. Run the tubing for your gauge. The gauge's height should be even or simply slightly less than the cheapest level you need to indicate for that fundamental calibration to operate. The tube in the tank, another valve and also the gauge really should be associated with the Tee. Mount the PSI gauge face side up therefore the realizing element won't trap sediment. The valve around the Tee enables eliminating the gauge tube from time to time to get rid of sediment.
5.
Calibrate your level system and make an amount-reading through dial to point level directly. In case your application is really a 20-feet-high tank (240 inches), divide 240 by 27.71 to yield 8.66 PSI. Select a zero to 10 PSI gauge. Eliminate a concentric plastic dial that matches round the outdoors from the gauge. Mark a scale to align using the pressure blood pressure measurements around the gauge. In the 8.66 PSI point, mark "20 ft" in the zero point, mark "" mark "5 ft" at 2.16 PSI "10 ft" at 4.33 PSI and "15 ft" at 6.5 PSI. Space out singlefeet markings between these blood pressure measurements as well as your direct-reading through level indicator utilizing a PSI pressure gauge is going to be close enough.
Making the effort to locate a pressure gauge having a low range that matches the application may be worth your time and effort. Learn more about liquid level gage at Quest-Tec Solutions http://questtecsolutions.com/.