How to H ang Louvered Doors
Since louver comes in different sizes, there are types like bi-fold doors and cabinet doors. Hanging a Louvered Doors might take few hours. Installing the top track by measuring the top jamb width and divide into two parts, move the track up and mark the screw holes, adjusting the track up and down to drill the starter holes for the screws. After the top track installation, also the bottom track is also installed, getting the right spot by a plumb bob, measure the bottom of the track at the floor, line is drawn from one end to the other at the bottom track then install. Installing the door by placing a bottom pivot spot into the lower track measurements, the top track is carefully inserted at the top end into the pivot spot. It will look a bite spring loaded; it should be adjusted and carefully inserted into it. The sliding guides are put up into the top and bottom tracks respectively, if need change the position of the adjustment of the door with the track socket and the lower anchor if they are two doors to be installed similar installation principle should be applied as the first one was done. The louver doors are mostly found in closets, so this must be proper inserted in the place where required because, if not properly done could lead to the loosen of the screws from its position and can destroy all the calibrations that have been done. Proper measurements of the upper and lower jack must be checked and balance, pivot point must be well noted my good measuring tapes where need, and the points of insertion of the screw must all be in good position then the installation will be carried out fully. This is the simple principle of hanging the louver doors, into the fitted place where needed. After all is done, this will allow free flow of air in and out of the stated regions of placement, It is a lovely way of making you louver doors done in safe time.