SLP Batteries

We are now launching a serie of modern ready to use batteries suitable for trucks, buses and marine applications featuring: high performance, maintenance free, good vibration resistance, good deep-charge performance and less sulphidation compared to traditional lead-acid batteries.

Absorbent Glass Mat (AGM) battery with high cyclic durability, totally maintenance free as well as good vibration durability and low self-discharge. This fire protected AGM battery is suitable for applications with higher energy consumption as a service battery for both truck/ bus and marine applications. Fulfil C20 as well as C5 and C100 standards.

NOTE: Not to be used as a starter battery!

• 205 Ah

• 12 Volt

• CCA N/A

• Weight 64 kg

• Battery base B00

• Box type D6

• Pole type 1

• Polarity 3

An AGM battery suitable for mid/large-sized trucks/buses that are running in regional/long haulage traffic with heavy electrical usage such as a lot of engine start/stops, cab-heater, seat/ mirror/ windscreen heating or spending the night in the cab. Preferably used in countries with cold climate. Suitable for start/stop functionality.

• 200 Ah

• 12 Volt

• CCA 1150 A

• Weight 65 kg

• Battery base B00

• Box type D6

• Pole type 1

• Polarity 3

Part No. BATT-140

Enhanced flooded battery suitable for small/mid-sized trucks/buses that are running in cities or regional traffic with relatively few and low energy consumers or a modest usage of high consumers such as tail-lift. Ideal for countries with warm-mild temperatures.

• 140 Ah

• 12 Volt

• CCA 900 A

• Weight 36 kg

• Battery base B00

• Box type D4

• Pole type 1

• Polarity 3

Part No. BATT-180

Enhanced flooded battery suitable for small/mid-sized trucks/buses that are running in cities or regional traffic with medium electrical usage such as tail-lift, seat/mirror heating, frequent engine start/stops.

• 180 Ah

• 12 Volt

• CCA 1100 A

• Weight 45 kg

• Battery base B00

• Box type D5

• Pole type 1

• Polarity 3

Part No. BATT-225

Enhanced flooded battery suitable for mid/large-sized trucks/buses that are running in regional/long haulage traffic with heavy electrical usage such as a lot of engine start/stops, cab-heater, seat/mirror/ windscreen heating or spending the night in the cab. Preferably used in countries with cold climate.

• 225 Ah

• 12 Volt

• CCA 1200 A

• Weight 56 kg

• Battery base B00

• Box type D6

• Pole type 1

• Polarity 3

General

To ensure a long life of the battery, make sure to minimize deep discharge on flooded batteries. When you calculate the need of battery power avoid exceeding 50% of the battery capacity. Even if the battery can handle a few deep discharges, it will deteriorate faster. Furthermore, a poorly charged battery can easily freeze in cold temperatures and damage the casing as well as the inside. All batteries have a self-discharge even if it is not connected to any consumers. When stored make sure to check battery status and recharge when needed. Use appropriate charger for AGM. Self-discharge occurs less in lower temperatures as well as charging less efficient. Never replace a vehicle’s factory fitted AGM battery with a flooded lead acid battery. Vehicles with factory fitted AGM’s use functions specifically with AGM technology in mind. Batteries connected in series should always be replaced together. Both batteries must have same voltage and amperage. When leaving our warehouse they are checked and charged.

• Always replace connected batteries together

• Avoid deep discharge (< 50%) for flooded batteries

• Never replace an AGM battery with a flooded battery

• Connected batteries must have the same state of charge, amperage-rating and technology

Swedish Lorry Parts

Swedish Lorry Parts is a Swedish company specializing in replacement parts suitable for Volvo and Scania trucks, buses, off road vehicles and industrial and marine engines. Thanks to a well-stocked warehouse and top modern logistics we normally send deliveries the same day as orders are placed.