Available NATIONWIDE
Hire Desk: 0870 240 2381
TPA Product Profile
This lightweight foam RRAP system has been designed to enable road rail vehicles and equipment to mount or cross the rail quickly and safely. An example installation video overview can be viewed at;
Rapid Rail Access
www.tpa-rrap.com
Network Rail Approved, Lightweight Foam Track Access System, for on/off tracking of RRV’s. TPA is firmly established in the rail sector as “the” principle provider of safe, effective, value for money temporary roadways, walkways & access systems. The lightweight foam rail track access system is a further new addition to TPA’s range of portable access equipment. With its customary rapid installation time, this new RRV rail track access system shall provide a superb all round solution to the on and off tracking of road rail vehicles.
The Benefits The crossing or access point is made from two metre long foam sections, each of which weighs under 25kg so they can be easily hand-carried into position. Only simple site preperation is required and the system provides the following benefits; 1. Lightweight each section weighs under 25kg. 2. Available in two metre kits. 3. Approved for use up to 15 tons per axle. 4. Network Rail Approval Number PA05/03446. 5. Simple site preparation. 6. Easily transported to and from the access point. The Process The lightweight foam system allows operators on site to construct a road rail access point (RRAP) easily.
Rapid Rail Access
Lightweight Foam RRAP
TPA Rapid Rail Access System
LW Foam Specifications Dimensions • Available in two-metre kits. • Multiple kits can be used to extend the length of the RRAP. Weight • Lightweight - each section weighs under 25kg. System Parts Each two-metre ramp kit consists of 2 outer ramp sections and 1 inner deck section with 2 centre end ramps.
•
Load Bearing Capacity Approved for use up to 15 tonnes per axle. Maximum 30 tonnes gross weight.
• •
Installation Time Full ramp kit, inclusive of five full track access point (bridge) sections can be fully installed and ready for use in less than 20 minutes. • Easily transported to and from the access point. Note The Lightweight Foam RRAP is not approved to be used on the Bull Head Track style of rail line, due to the clearance and “chairs” in which the rail sits.
•
Specifications are subject to change without notice Trademarks are the property of TPA or their respective owners.
T: 0870
The ramps are suited for use on flat bottom plain line with a sleeper spacing of 650mm (28 per 60ft rail). The recesses for the clips will allow for some variation in the sleeper spacing.
Quick Handling Each section has a hand hold for ease of handling. While each section is under 25kgs, it is easier and safer for two men to lift each section, due to the size.
RISQS & Link-up Achilles Registered Supplier Number 058540
© 2017 TPA All Rights reserved
W: www.tpa-rrap.com
Innovative Solution
The purpose of the Foam Rail Ramps is to provide an easy to install temporary RRAP for the on/off/cross tracking of RRV’s fitted with road wheels and having axle loads up to 15 tonnes.
Protective
•
Rapid Rail Access
Highlights
240 2381
Document Issue date 16/07/15 Document Version 1.6
E: info@tpa-rrap.com