T & S Machine

BLOCKMASTER BLOCKMASTER CNC BLOCK CNC BLOCK MACHINING SYSTEM MACHINING SYSTEM

Probe, bore and deck a block in 20 minutes. While Probe, bore and deck a block in 20 minutes. While you are there clearance the block for stroker cranks. you are there clearance the block for stroker cranks. Since you just decked it, go ahead and O-Ring the Since you just decked it, go ahead and O-Ring the deck since we have the operation saved. deck since we have the operation saved. We are just as comfortable boring a V-8 and We are just as comfortable boring a V-8 and following it with a six-cylinder inline and then a following it with a six-cylinder inline and then a V-6 60 degree with no saved programs or special V-6 60 degree with no saved programs or special setups. We have built and automated job shop setups. We have built and automated job shop block machining! block machining! Anyone with engine building knowledge can run Anyone with engine building knowledge can run the BlockMaster after a couple of days with the the BlockMaster after a couple of days with the included factory training in your shop. included factory training in your shop.

PROBAL 500 DELUXE PROBAL 500 DELUXE CRANKSHAFT BALANCER CRANKSHAFT BALANCER

You might ask, “Maybe there is a ‘better’ You might ask, “Maybe there is a ‘better’ system out there?”, we don’t believe system out there?”, we don’t believe so! T&S has invested heavily in building so! T&S has invested heavily in building the quickest, most sensitive and accurate the quickest, most sensitive and accurate balancing software available. We can balancing software available. We can perform measurements in less than three perform measurements in less than three seconds. We calculate drill depths, and seconds. We calculate drill depths, and when we tell you to drill in a particular when we tell you to drill in a particular location there is no chasing the angle location there is no chasing the angle back and forth. We have built-in reports back and forth. We have built-in reports showing the customer what the actual showing the customer what the actual necessary tolerance for each crankshaft is necessary tolerance for each crankshaft is and the actual balance achieved. A more and the actual balance achieved. A more sophisticated balancing software does not sophisticated balancing software does not exist, and we can prove it. exist, and we can prove it.

T&S uses the same system for balancing turbocharger rotors as for 15,000 lb electric T&S uses the same system for balancing turbocharger rotors as for 15,000 lb electric motor armatures and GM locomotive crankshafts that are twenty feet long. motor armatures and GM locomotive crankshafts that are twenty feet long. Even those extremely large parts have only a six second sample time! Even those extremely large parts have only a six second sample time! T&S does not just offer an attachment to drill for heavy metal, we build T&S does not just offer an attachment to drill for heavy metal, we build the heavy metal stand into the base of the machine. We knew we were the heavy metal stand into the base of the machine. We knew we were going to balance crankshafts when we built it so we held a crankshaft going to balance crankshafts when we built it so we held a crankshaft up in the air and built the ultimate machine around it. We include up in the air and built the ultimate machine around it. We include all necessary accessories with the machine. And we do this all all necessary accessories with the machine. And we do this all for less than any of our competitors. As an added bonus our for less than any of our competitors. As an added bonus our PB500 has the smallest footprint of any machine in the PB500 has the smallest footprint of any machine in the industry, AND the machine is manufactured right here in industry, AND the machine is manufactured right here in the Republic of Texas! the Republic of Texas! All accessories available All accessories available