SKYLITE V2 Installation Manual
English
ATTENTION: In order to function properly, SkyLite V2 must be connected to a dimmable driver/ballast. NOTE: Some dimmable drivers/ballasts must be programmed/set to dimmable mode. If this has not been done, SkyLite V2 will not be able to dim the connected armature.
TVILIGHT BV / Westerhaven 13, 9718 AW Groningen, the Netherlands +31 (0)50 800 3240 / info@tvilight.com / www.tvilight.com
v 1.0 30/06/2015
In box: SkyLite V2
External Antenna
Cable Assembly
120 mm
55 mm
You’ll need: Drill
10.5 mm
Screw Driver
Page 3 of 10
1. Connect Cable Assembly
2. Open Armature
Page 4 of 10
3. Access Electronic Gear
4. Drill hole in top of Armature
Page 5 of 10
5. Place Antenna through hole
6. Tighten Antenna using Antenna Nut
Page 6 of 10
7. Place SkyLite V2 Screw into place
8. Connect Antenna to SkyLite V2 Tighten SMA connector with a torque of 0.8 Nm (finger tight)
Page 7 of 10
9. Connect SkyLite to Driver
Page 8 of 10
Wiring Diagram
To Armature
TVILIGHT SKYLITE V2
Driver
DC- DC+ N
L
GND N L DC+ DC-
AC1 AC2 AC3
To Mains
Page 9 of 10
10. Return Electronic Gear to position and close Armature
Page 10 of 10