Engine - Engine and crankcase

Engine - Install DANGER

Heavy objects!

Lift and handle all heavy components using lifting equipment with adequate capacity . Always support units parts with suitable slings hooks. Make sure the work area clear all bystanders. Failure comply will result death serious injury

Attach proper lifting straps the eye hooks (1) vided the front right and rear left the engine.

Using a suitable hoist carefully lower engine into engine compartment the skid steer .

Slowly orient the hydraulic pump coupler the adapter the engine ensuring the attachment engine plate flywheel

Apply L OCTITE ® 243 the threads the bolts (2) . tach engine hydraulic pump mounting plate using the twelve mounting bolts (2) T ighten the mounting bolts (2) a torque - N·m ( - )

Engine - Engine and crankcase

10.

Connect ground from the quick battery disconnect the engine (7) remote engine oil filter lines (8) .

13. Connect the fuel supply line .

14. Connect the wire harness (12) and clamps (13) the top the flywheel

Connect throttle cable installing the nut (A) and bolt (B) the throttle body Install cable support clamp (C) and tighten the two hex head bolts (D)

Connect oil pressure sender wire (14) and support (15)

Thank you very much for your reading. Please Click Here. Then Get COMPLETE MANUAL.NOWAITING

NOTE:

If there is no response to click on the link above, please download the PDF document first and then clickonit.

Engine - Engine and crankcase

25. Install muf fler inlet pipe mounting flange bocharger and secure with the five mounting bolts (25) T ighten mounting bolts (25) a torqueN·m ( - )

931002028

26. Install the two retaining bolts (26) the muf fler

931002029

Place fan hub and secure with the four ing bolts (A) T ighten the four retaining bolts (A) a torque - ( - )

931002027

Install oil cooler See Oil cooler / Heat exchangerInstall (35.300)

Install radiator See Radiator - Install

Add engine

Fill hydraulic oil reservoir See Oil reservoir - Filling (35.300)

Fill See Radiator - Filling

Install Install rear access door See

Throttle linkage - Adjust

L213 TIER 3 [NEM4591 - ]

W Arning

A void injury!

Always engage the parking brake and switch off the engine before working the machine. Failure comply could result death serious injury .

Before adjust the please inspect all linkage components for wear and Replace components essary

Start the Press and hold the auxiliary ride button (1) for two Release the then press the auxiliary override button (1) toggle next display Continue press and release the auxiliary override button (1) until RPM

Adjust the clevis (1) the end the foot that within the first five degrees handle the pedal starts move. the pedal does not move with the throttle turn the clevis shorten the

Loosen the jam nut (1) , and turn the stop bolt (2) several turns

NOTE: Make sure the plunger through the L - bracket when the jam nut The plunger must move freely through the L - not pinch the L - bracket between the plunger and the washer