SER VICE MANUAL

T8010 [Z8Rx06001 - ]

T8020 [Z8Rx06001 - ]

T8030 [Z8Rx06001 - ]

T8040 [Z8Rx06001 - ]

T8050 [Z8Rx06001 - ] 84318454

PRIMAR Y

PRIMAR Y

PNEUMA TIC SYSTEM

ELECTRICAL POWER SYSTEM

LIGHTING SYSTEM

FRONT AXLE

2WD - 4WD SYSTEM Hydraulic

STEERING Hydraulic

SER VICE BRAKE Hydraulic

P ARKING BRAKE Hydraulic

BRAKE

USER

HITCH Rear hitch

Introduction

W Arning

Hydraulic fluid escaping under pressure can have enough force penetrate the skin. Hydraulic fluid may also infect a minor cut opening the skin. injured escaping fluid, see a doctor once. Serious infection reaction can result medical treatment not given immediately Make sure all connections are tight and that hoses and lines are good condition before applying pressure the system. Relieve all pressure before disconnecting the lines performing other work the hydraulic system. T o find a leak under pressure use a small piece cardboard Never use Failure comply could result death serious injury .

M252A

W Arning

When removing hardened pins such a pivot pin, a hardened shaft, use a soft head (brass bronze) hammer use a driver made from brass bronze and a steel head hammer

M497

W Arning

When using a hammer remove and install pivot pins separate parts using compressed air using a grinder , wear eye protection that completely encloses the eyes (approved goggles other approved eye

M498

W Arning

Use suitable floor (service) jacks chain hoist raise wheels tracks off the floor . Always block machine placed with suitable safety stands.

M499

W Arning

When servicing repairing the Keep the shop floor and operators compartment and steps free oil, water , grease, tools, etc. Use oil absorbing material and shop cloths required. Use safe practices all times.

M500

W Arning

Batteries contain acid and explosive Explosions can result from flames wrong cable nections. T o connect the jumper cables correctly the battery this machine see the Operators Manual. Failure follow these instructions can cause serious injury death. M504