Safety rules

This warning symbol points out important messages involving personal safety Carefully read the safety rules contained herein and follow advised precautions avoid potential hazards and safeguarded your safety .

this manual you will find this symbol together with the following

W ARNING: gives warning about improper repair operations and potential consequences fecting the service s personal safety

DANGER: gives specific warning about potential dangers for personal safety the operator other persons directly indirectly involved the operation.

T o prevent accidents

Most accidents and personal injuries taking place workshops are due from non - observance some essential rules and safety

The possibility that accident might occur with any type machines should not disregarded, matter how well the machine question was designed and

A wise and careful service technician the best precautions against accidents. Careful observance this only basic precaution would enough avoid many severe

Danger

Never carry out any lubrication maintenance operations when the engine

Safety rules

Generalities

Carefully follow specified repair and maintenance

• not wear rings, wrist watches, jewels, unbuttoned flapping clothing such ties, torn clothes, scarves, open jackets shirts with open zips which could get caught moving Use approved safety clothing such anti - slipping footwear , safety

• W ear safety glasses with side guards when cleaning parts using compressed air

• Damaged frayed wires and chains are not use them for lifting

• W ear suitable protection such approved eye special gloves and footwear whenever All persons standing vicinity the welding process should wear approved eye Never look the welding arc your eyes are not suitably

• Never carry out any repair the machine someone sitting the operator ’ s except they are qualified operators assisting the operation carried

• Never operate the machine use attachments from a place other than sitting the operator ’ s seat the side the machine when operating the fender

• Never carry out any operation the machine when the engine running, except when specifically indicated. Stop the engine and ensure that all pressure relieved from hydraulic circuits before removing

• All repair and maintenance operations should carried out with greatest care and attention.

• Disconnect the batteries and label all controls warn that the tractor being Block the machine and all equipment which should

• Never check fill fuel tanks nor use starting liquid you are smoking near open flames such fluids are

• The fuel filling gun should always remain contact with filler Maintain this contact until the fuel stops flowing into the tank avoid possible sparks due static electricity build -

• T o transfer a failed tractor , use a trailer a low loading platform trolley available.

• T o load and unload the machine from the transportation select a flat area providing a firm support the trailer truck Firmly tie the machine the truck the trailer platform and block wheels required the transporter

• Always use lifting equipment appropriate capacity lift move heavy

• Chains should always safely Ensure that fastening device strong enough hold the load persons should stand near the fastening

• The working area should always kept clean and dry . Immediately clean any spillage water oil.

• Never use diesel oil other flammable liquids cleaning Use non - flammable non - toxic proprietary solvents.

• not pile grease oil soaked they constitute a great fire Always place them into a metal container

Start

• Never run the engine confined spaces which are not equipped with adequate ventilation for exhaust gas

• Never bring your body , fingers near fans rotating

Engine

• Always loosen the radiator cap very slowly before removing allow pressure the system Coolant should topped only when the engine stopped.

• not fill fuel tank when the engine

• Never adjust the fuel injection pump when the tractor moving. Never lubricate the tractor when the engine 47899732

Introduction

Electrical systems

• necessary use auxiliary batteries, cables must connected both sides follows. (+) (+) and ( ( A void short - circuiting the Gas released from batteries highly During leave the battery compartment uncovered improve A void sparks flames near the battery not

• not charge batteries confined

• Always disconnect the batteries before performing any type service the electrical system.

Hydraulic systems

• Some fluid coming out from a very small port can almost invisible and strong enough penetrate skin. For this Never use your hands check for but use a piece cardboard a piece wood for this any fluid injected into the seek medical aid immediately Lack immediate medical attention may result serious infections

• Always take system pressure readings using the appropriate

Wheels and tires

• Check that the tires are correctly inflated the pressure specified the manufacturer Periodically check for possible damage the rims and

• Stay a the tire side when

• Check the pressure only when the tractor unloaded and tires are cold avoid wrong reading due over -

• Never cut, nor weld a rim with the inflated tire assembled.

• T o remove the block both front and rear tractor Raise the tractor and install safe and stable supports under the tractor accordance with the regulations

• Deflate the tire before removing any object caught into the tire

• Never inflate tires using flammable gases they may originate explosions and cause injuries

Removal and installation

• Lift and handle all heavy components using lifting equipment adequate capacity Ensure that parts are supported appropriate slings and Use lifting eyes provided this T ake care the persons near the loads

Engine -

Engine and crankcase - 001

Engine - Engine and crankcase