Fig.1
Time zone 1 Time zone 2 No time control
This terminal must be connected from the controller to a thermostat if a thermostat is used for this channel
UPONOR C-35 CONTROL CENTRE Auto Link 01
2
Optional Timer I-36 (When using T36 or dial T37 stats)
Auto Link POWER
02 03
6 7 4 5 1
Auto Link
One of these three terminals must be connected from the Controller C-35 to a thermostat if a thermostat is used for this channel
04
05
06
07
Switched Fuse Spur 3 Amp Fuse
1 2 11 12
01
02
03
04
05
06
E L N
1
2
Digital Thermostat with Timer Functions T-38
1
2
Digital Thermostat T-36
1
2
Connect to Switch Live (A)
Basic Dial Thermostat T-37
Controller (C-35) notes, The diagram below shows the Controller (C-35) linked to an optional Timer (I-36), five thermostats and ten 24V actuator heads. Only 6 of the 12 channels are shown for clarity. Each thermostat requires two cables to be wired to two of the four thermostat connections. The bottom connection must be made. The second wire should be connected to one of the three remaining terminals depending on whether the Timer (I-35) is being used and if so, which of the two time channels is being used. See Fig 1.