The Ultimate How-To Guide to Build your Coil So, if you have decided to build your own vape coil but don’t know how to build it and where to start, Here is step by step guide.
VapourDepot.com
What you’ll need?
1) Rebuildable Dripping Atomizers (RDA)
VapourDepot.com
2) Ohm Reader
VapourDepot.com
3) Scissors
VapourDepot.com
4) Resistance wire
VapourDepot.com
5) Small propane torch
VapourDepot.com
6) Thin wire cutters
VapourDepot.com
7) Thin wire cutters
VapourDepot.com
8) Organic cotton
VapourDepot.com
9) Pliers or Tweezers
VapourDepot.com
Before you actually start with the coil building process, you need to know the different types of coils you can make at home. These include:
Single Coils
Twisted Coils
Clapton Coils
Dual Coils
Let's start Oxidizing the wire
Cut a 4-5 inch wire, hold its one end with a pair of tweezers or pliers. Now, slowly heat the wire by using torch until it starts getting orange. Let the wire cool and repeat the same process by holding the other end. Oxidizing the wire will not only make it less
Wrapping the coil
Place the wire at the screwdriver’s base. Leave one end longer than the other while wrapping the coil. With the help of your finger, hold the wire against the screwdriver.
You would wrap the wire about 6-8 times, depending on the size of the RDA.
Installing the coil
Next, take the build deck of RDA and loose the post screws. Don’t remove the screws completely as they are easy to lose but are hard to put back. Take the coil (that is still on the screwdriver) and position both the leads in the positive post hole and negative post hole, respectively.
Now, you are done with the coil building process; check the structure and ensure it is built accurately.
Happy Vaping........ Looking for a reputed vape store? Visit
Vapourdepot.com