LITEAIRAUTO8-V1 LITEAIRAUTO8A-V1
Please ensure that when installing this product the heatsink will not contact with any materials that mat be damaged by heat such as upholstery or plastics.
LITEAIRAUTO8A-V1
Connect to +12V of battery with attached 20 amp fuse
R
L
REM GND
Connect to chassis ground of vehicle
+12V
Connect to chassis ground of vehicle
Connect to speaker output of headunit R + white R - white / black L + grey L - grey / black
L
R
Connect to RCA (low level) output of headunit
Connect to supplied bass remote NOTE: if the remote is not connected the ampliďŹ er will default to minimum frequency and minimum gain setting
LITEAIRAUTO8-V1
Connect to Speaker output of amplifier
NOTE: VIBE recomends the LiteAir Bass 1 ampliďŹ er as the perfect partner for the LITEAIRAUTO8-V1
The LiteAir Auto 8 subwoofer enclosure can be mounted in many different locations in the vehicle due to it’s shallow profile. Below are a few examples of different mounting applications that are possible with the LiteAir Auto 8 subwoofer enclosures.
Rear of seat
Under seat
Side panel
Please follow the installation method below to secure the enclosure to your chosen mounting location.
Step 1: Fold out the steel mounting tabs from underneath the enclosure
Step 2: Secure the enclosure with 4 screws.
Note: Be sure to investigate your mounting area thoroughly for electrical wires, brake or fuel lines or fuel tank to prevent causing any damage. If you are unsure VIBE recommend that the enclosure is installed by an authorised VIBE dealer.
Terminals & controls LITEAIRAUTO8-V1
LITEAIRAUTO8A-V1
1
9
5
6
8
7 1.
2.
3. 4. 5. 6.
7.
8.
9.
Speaker terminal Connect to the speaker output of the amplifier
3 4
2
LiteAir Optisound Auto 8 Part Number: Peak Power: RMS Power: Height: Width: Depth: Impedance:
LITEAIRAUTO8-V1 900 watts 300 watts 80mm (excl grill) 285mm 397mm 4 Ohms
LiteAir Optisound Auto 8 active Part Number: LITEAIRAUTO8-V1 Peak Power: 900 watts 300 watts RMS Power: Height: 80mm (excl grill) 285mm Width: Depth: 395mm 20 amp Fuse rating:
20 amp fuse