TIP: Decorative Embossed Washers
1
You will need a grouping of Natural Brass 10mm Standard Washers.
2
Place washers onto Lily Damask DecoEmboss Die to reflect the symmetrical pattern.
3
Carefully close the embossing folder die and crank it through BIGkick machine one time.
4
Use the white side of Metal Reliefing Block to highlight the raised areas.
5
Stack embossed washers on each side of Lampworked Caterpillar Bead and string two 6 inch pieces of 18g Half Round Artisan Copper Wire through holes. Be sure the flat side is facing outward, so once you bend the pieces the rounded side is showing along the washer and bead.
6
Cross over the wire tails and begin to create coils to secure. Form a wrapped loop with remaining piece of wire and repeat on opposite side. Use Flush Cutters to trim any excess wire.
Check o
ut our
blog a www.v intaj.c t: For m om/wp ore tec blog hnique design s, er highlig
hts an
stunni ng d mor designs, e!
*TIP* Vintaj Patinas can also be applied after washers have been embossed to add an extra pop of color to your decorative washers.